单选题Which Ethernet field is used to differentiate between the FCoE frame and the FIP frame？（）A Ethernet FCSB Source addressC Destination addressD EtherTypeE Protocol type
单选题
Which Ethernet field is used to differentiate between the FCoE frame and the FIP frame？（）
A
Ethernet FCS
B
Source address
C
Destination address
D
EtherType
E
Protocol type
参考解析
解析：
暂无解析
相关考题：
When multiple PPP over Ethernet subscribers connect using the same DSL modem, which two attributes does the ERX use to differentiate between subscribers? ()(Choose two.) A. PPP session IDB. subscriber nameC. source MAC addressD. destination MAC address
Two buildings on the San Jose campus of a small company must be connected to use Ethernet with a bandwidth of at least 100 Mbps. The company is concerned about possible problems from voltage potential differences between the two buildings. Which media type should be used for the connection（）。A.UTP cableB.STP cableC.coaxial cableD.fiber optic cable
The most commonly used locking level in implementing concurrency control is at which of the following levels?A．databaseB．tableC．recordD．field
Which two characteristics are common between traffic policing and traffic shaping？（）A、 The rate of traffic is measured and compared to a configured policy.B、 Classification is used to differentiate traffic.C、 Traffic is marked and sent out according to priority.D、 Both can be applied to inbound and outbound traffic.E、 Both buffer traffic to ensure a predetermined traffic rate.F、 Both drop traffic that is above a predetermined traffic rate.
Which three statements about NetFlow are true？ （）A、LCP is used for PPP over ATM （PPPoA） setup.B、LCP is used for PPP over Ethernet （PPPoE） setup.C、LCP is used for PPP over Ethernet （PPPoPR） setup.D、LCP is used for PPP CHAP authentication.E、LCP is used for basic PPP link setup and operation.
ISL is being configured on a Company switch. Which of the following choices are true regarding the ISL protocol？ （）A、 It can be used between Cisco and non-Cisco switch devices.B、 It calculates a new CRC field on top of the existing CRC field.C、 It adds 4 bytes of protocol-specific information to the original Ethernet frame.D、 It adds 30 bytes of protocol-specific information to the original Ethernet frame.
What is the purpose of a network mask?（）A、It is used in conjunction with the wildcard mask to determine the number of hosts on a networkB、It is used to define which parts of the IP address are allocated to host addresses and network prefixesC、It is used to hide subnets from external networks by masking the subnets with NATD、It is used to differentiate a network as a classful network or a classless network
Which of the following statements is true regarding the VERSIONS BETWEEN clause？（） A、 The VERSIONS BETWEEN clause may be used in DML statements.B、 The VERSIONS BETWEEN clause may be used in DDL statements.C、 The VERSIONS BETWEEN clause may not be used to query past DDL changes to tables.D、 The VERSIONS BETWEEN clause may not be used to query past DML statements to tables.
For what two purposes does the Ethernet protocol use physical addresses？（）A、to uniquely identify devices at Layer 2B、to allow communication with devices on a different networkC、to differentiate a Layer 2 frame from a Layer 3 packetD、to establish a priority system to determine which device gets to transmit firstE、to allow communication between different devices on the same networkF、to allow detection of a remote device when its physical address is unknown
Which Ethernet field is used to differentiate between the FCoE frame and the FIP frame？（）A、 Ethernet FCSB、 Source addressC、 Destination addressD、 EtherTypeE、 Protocol type
Two buildings on the San Jose campus of a small company must be connected to use Ethernet with a bandwidth of at least 100 Mbps. The company is concerned about possible problems from voltage potential differences between the two buildings. Which media type should be used for the connection（）。A、UTP cableB、STP cableC、coaxial cableD、fiber optic cable
A laser printer has a vertically repetitive print defect. Before attempting to repair the printer，a technician should determine：（）A、the distance between the spots.B、which paper tray was used to print the document.C、which driver was used to print the document.D、which application was used to print the document.
A customer is debating whether to use Shared Ethernet versus Virtual Ethernet. Which of the following best describes a key difference between Shared and Virtual Ethernet？（）A、Shared Ethernet runs on POWER4 systemsB、Virtual Ethernet runs on POWER4 systemsC、Shared Ethernet requires a Virtual I/O server and Advanced Power VirtualizationD、Virtual Ethernet requires a Virtual I/O server and Advanced Power Virtualization
jim has created a field hint for the address field. Users tell him this text disappears when they click in the address field. which one of the following is most likely reason?（）A、 the address field is computed B、 jim should have used a text popup C、 jim stored the field hint in the database D、 field hint only display when the user has not clicked in the field （field hint）
which one of the following accurately describes field names?（）A、they must be unique in a database B、they can only be used once in a view C、they can only used once on each form D、they can be used mulriple times on a form
What is the role of route preference?（）A、It is used as a tie breaker when the same prefix is available through multiple sourcesB、It is used to determine which routes to accept into the routing tableC、It is used to select the best route between multiple equal-cost pathsD、It is used to select which routing table to use for forwarding
单选题which one of the following accurately describes field names?（）Athey must be unique in a database Bthey can only be used once in a view Cthey can only used once on each form Dthey can be used mulriple times on a form
单选题jim has created a field hint for the address field. Users tell him this text disappears when they click in the address field. which one of the following is most likely reason?（）A the address field is computed B jim should have used a text popup C jim stored the field hint in the database D field hint only display when the user has not clicked in the field （field hint）
多选题ISL is being configured on a Company switch. Which of the following choices are true regarding the ISL protocol？ （）AIt can be used between Cisco and non-Cisco switch devices.BIt calculates a new CRC field on top of the existing CRC field.CIt adds 4 bytes of protocol-specific information to the original Ethernet frame.DIt adds 30 bytes of protocol-specific information to the original Ethernet frame.
多选题For what two purposes does the Ethernet protocol use physical addresses？（）Ato uniquely identify devices at Layer 2Bto allow communication with devices on a different networkCto differentiate a Layer 2 frame from a Layer 3 packetDto establish a priority system to determine which device gets to transmit firstEto allow communication between different devices on the same networkFto allow detection of a remote device when its physical address is unknown
单选题Which Ethernet field is used to differentiate between the FCoE frame and the FIP frame？（）A Ethernet FCSB Source addressC Destination addressD EtherTypeE Protocol type
单选题Which message is used to transport routing information between BGP peers?（）AOpenBActiveCUpdateDKeepalive
多选题Which three statements about classification marking of traffic at Layer 2 are true？ （）Aa Frame Relay header includes a 1-bit discard eligible （DE） bit to provide the class of service （CoS）Ban ATM header includes a 1-bit DE field to provide the CoSCan MPLS EXP field is inserted in the Layer 3 IP precedence field to identify the CoSDthe CoS field only exists inside Ethernet frames when 802.1Q or Inter-Switch Link （ISL） trunking is usedEin the IEEE 802.1p standard， three bits are used to identify the user priority bits for the CoSFin the IEEE 802.1q standard， six bits are used to identify the user priority bits for the CoS
多选题Which two characteristics are common between traffic policing and traffic shaping？（）AThe rate of traffic is measured and compared to a configured policy.BClassification is used to differentiate traffic.CTraffic is marked and sent out according to priority.DBoth can be applied to inbound and outbound traffic.EBoth buffer traffic to ensure a predetermined traffic rate.FBoth drop traffic that is above a predetermined traffic rate.
多选题Which three statements about NetFlow are true？ （）ALCP is used for PPP over ATM （PPPoA） setup.BLCP is used for PPP over Ethernet （PPPoE） setup.CLCP is used for PPP over Ethernet （PPPoPR） setup.DLCP is used for PPP CHAP authentication.ELCP is used for basic PPP link setup and operation.
单选题Which of the following statements is true regarding the VERSIONS BETWEEN clause？（）A The VERSIONS BETWEEN clause may be used in DML statements.B The VERSIONS BETWEEN clause may be used in DDL statements.C The VERSIONS BETWEEN clause may not be used to query past DDL changes to tables.D The VERSIONS BETWEEN clause may not be used to query past DML statements to tables.
多选题When multiple PPP over Ethernet subscribers connect using the same DSL modem, which two attributes does the ERX use to differentiate between subscribers? （）(Choose two.)APPP session IDBsubscriber nameCsource MAC addressDdestination MAC address
单选题What is the purpose of a network mask?（）AIt is used in conjunction with the wildcard mask to determine the number of hosts on a networkBIt is used to define which parts of the IP address are allocated to host addresses and network prefixesCIt is used to hide subnets from external networks by masking the subnets with NATDIt is used to differentiate a network as a classful network or a classless network