单选题How many volts does a power supply’s 4-pin Molex connector carry to internal devices?()A2.5 voltsB5 voltsC6 voltsD15 volts

单选题
How many volts does a power supply’s 4-pin Molex connector carry to internal devices?()
A

2.5 volts

B

5 volts

C

6 volts

D

15 volts


参考解析

解析: 暂无解析

相关考题:

How many bytes does an IP adress consist of?

A technician is testing a power supply for correct output voltages at the HDD power connector.Which of the following voltages should the technician expect for a correctly working power supply?() A.6VB.9VC.12VD.24V

A technician is installing a new power supply into a computer. One of the power supply connectors that the technician needs to connect to the motherboard is square and contains 4-pins. This connector is known as which of the following?()A.SATAB.FDDC.IDED.ATX

When a power supply does not meet minimum requirements for a motherboard, which of thefollowing can happen?() A. Computer will not POSTB. Computer will overheatC. Monitor will not power onD. Processor will not run at proper speed

Which of the following voltages can be measured from a Molex connector on the power supply?() A. 1.5 voltsB. 3 voltsC. 5 voltsD. 12 voltsE. 115 volts

Which of the following would represent a power supply connector that supplies the main power toan ATX motherboard?() A. 6-pin PCI connectorB. 24-pin connectorC. Molex connectorD. SATA connector

A new floppy drive was just installed into a PC. The drive powers on at system boot but the status LED does not turn off during operation. Which of the following is MOST likely the issue?()A、The power cable was installed incorrectly and needs to be flipped.B、The floppy drive was not enabled within the motherboard’s BIOS.C、The FDD cable was installed incorrectly and needs to be flipped.D、A Molex power cable was used instead of a Berg cable.

If a technician suspects that the voltage being delivered to a desktop computer’s power supply is insufficient or incorrect, which device should be used to determine the correct voltage?()A、A power supply testerB、A multimeterC、A loopback adapterD、A cable tester

A technician does not have power to a PC. Which of the following tools should the technician use to check for electricity?()A、Cable testerB、Power supply testerC、Tone generatorD、Multimeter

Which of the following is the voltage that an ATX molex connector delivers to an IDE device? ()A、-3.3 VoltsB、24 VoltsC、120 VoltsD、12 VoltsE、5 Volts

A technician receives a computer for repair and observes that the fan on the power supply is not moving. Which of the following should the technician do? ()A、Move the power supply voltage switch to 220 volts.B、Add an additional fan to help cool the computer.C、Replace the cable that attaches the power supply to the motherboard.D、Replace the power supply.

A technician is testing a power supply for correct output voltages at the HDD power connector. Which of the following voltages should the technician expect for a correctly working power supply?()A、6VB、9VC、12VD、24V

A military member has just returned to the United States from Europe and reports their personaldesktop computer does not work. Which of the following is the MOST logical solution to thisproblem?()A、The computer is unable to work in the US because of EU licensing arrangementsB、The power supply needs to be replaced with one rated for 110 wattsC、The power supply needs a power inverter to handle the change in cyclesD、The power supply voltage needs to be switched to 110 from 220

How many volts does a power supply’s 4-pin Molex connector carry to internal devices?()A、2.5 voltsB、5 voltsC、6 voltsD、15 volts

Which of the following connectors uses the main board ATX connector type?()A、CentronixB、20/24 pinC、BNCD、Molex

Which of the following voltages can be measured from a Molex connector on the power supply?()A、1.5 voltsB、3 voltsC、5 voltsD、12 voltsE、115 volts

A technician is installing a new power supply into a computer. One of the power supply connectors that the technician needs to connect to the motherboard is square and contains 4-pins. This connector is known as which of the following?()A、SATAB、FDDC、IDED、ATX

Which of the following would represent a power supply connector that supplies the main power toan ATX motherboard?()A、6-pin PCI connectorB、24-pin connectorC、Molex connectorD、SATA connector

When a power supply does not meet minimum requirements for a motherboard, which of thefollowing can happen?()A、Computer will not POSTB、Computer will overheatC、Monitor will not power onD、Processor will not run at proper speed

A BladeCenter S chassis with 2 storage modules requires how many power supplies?()A、1B、2C、4D、6

单选题A technician receives a computer for repair and observes that the fan on the power supply is not moving. Which of the following should the technician do? ()AMove the power supply voltage switch to 220 volts.BAdd an additional fan to help cool the computer.CReplace the cable that attaches the power supply to the motherboard.DReplace the power supply.

单选题A new floppy drive was just installed into a PC. The drive powers on at system boot but the status LED does not turn off during operation. Which of the following is MOST likely the issue?()AThe power cable was installed incorrectly and needs to be flipped.BThe floppy drive was not enabled within the motherboard’s BIOS.CThe FDD cable was installed incorrectly and needs to be flipped.DA Molex power cable was used instead of a Berg cable.

多选题Which of the following voltages can be measured from a Molex connector on the power supply?()A1.5 voltsB3 voltsC5 voltsD12 voltsE115 volts

单选题A BladeCenter S chassis with 2 storage modules requires how many power supplies?()A1B2C4D6

多选题Which of the following is the voltage that an ATX molex connector delivers to an IDE device? ()A-3.3 VoltsB24 VoltsC120 VoltsD12 VoltsE5 Volts

单选题A military member has just returned to the United States from Europe and reports their personaldesktop computer does not work. Which of the following is the MOST logical solution to thisproblem?()AThe computer is unable to work in the US because of EU licensing arrangementsBThe power supply needs to be replaced with one rated for 110 wattsCThe power supply needs a power inverter to handle the change in cyclesDThe power supply voltage needs to be switched to 110 from 220

单选题Which of the following would represent a power supply connector that supplies the main power toan ATX motherboard?()A6-pin PCI connectorB24-pin connectorCMolex connectorDSATA connector