开机时出现以下提示Primary IDE Channel no 80 conductor cable install是什么意思？
开机时出现以下提示Primary IDE Channel no 80 conductor cable install是什么意思？
相关考题：
这个英语句子是什么意思? Keep in mind that the web，transmitting by satellites，cellphone，cable，goes through no one central location that anyone controls
Which of the following is the MAXIMUM theoretical transfer rate of an IDE cable?() A. 1.54 MbpsB. 3.0 GbpsC. 133 MbpsD. 480 Mbps
Which of the following settings is the jumper set to when installing a DVD－RW as the second device on an IDE cable?() A. ID0B. ID2C. Cable selectD. Master
以下什么原因会造成IDE硬盘损害?() A.把IDE cable连接到软驱上B.连接IDE cable错误C.用一个Y分离器分别是5v和12v电压D.连接一个坏的电源，它12v电压的线上面只能输出5v电压
开机时出现以下提示PrimaryIDEChannelno80conductorcableinstall‖是什么意思（）A、系统不支持ＤＭＡ６６的功能B、系统支持ＤＭＡ６６的功能，但并没有安装专用的数据线C、数据电缆已经损坏D、ＩＤＥ接口已经损坏
Which of the following is the MAXIMUM theoretical transfer rate of an IDE cable?（）A、1.54 MbpsB、3.0 GbpsC、133 MbpsD、480 Mbps
A client purchased a new internal hard drive to act as a second drive on a legacy machine. When the client attempts to install the drive, the cable connector on the new drive is not compatible with the available IDE cables. It is determined that the client has purchased a SATA hard drive. Which of the following would the technician recommend as the BEST solution to this situation?（）A、Have the client purchase a SATA compatible system board.B、Have the client purchase a SATA to IDE conversion kit.C、Have the client return the drive and purchase an IDE compatible drive.D、Have the client purchase a SCSI to SATA conversion kit.
以下什么原因会造成IDE硬盘损害？（）A、把IDE cable连接到软驱上B、连接IDE cable错误C、用一个Y分离器分别是5v和12v电压D、连接一个坏的电源，它12v电压的线上面只能输出5v电压
计算机开机时总是自检到光驱后就停止，大约1分钟后出现“Primary master hard disk fail Press F1 to continue”的提示，按下F1键后出现“verfying dmi pool data……disk boot failure, inter system disk and press enter”提示，再次重新启动后即可正常使用，这是什么原因？
Which of the following settings is the jumper set to when installing a DVD-RW as the second deviceon an IDE cable？（）A、 ID0B、 ID2C、 Cable selectD、 Master
A customer has purchased a triple channel memory kit containing three DDR3 RAM modules. Theserver the RAM is intended for only has a dual channel capable motherboard. Which of the following is the BEST action to perform？（）A、Install only two modules as the RAM has to be installed in pairsB、Purchase one additional RAM module to make it even. Three modules will function as triplechannel and the additional module will be for parityC、Purchase dual channel memory. The triple channel memory may be incompatible with theserver motherboardD、Install the RAM.Two modules will perform as dual channel and one as single channel
An administrator is configuring RAID 1 in a server. The administrator has been given two matching 80GB SATA-2 hard drives， two SATA-2 cables， and a SATA-2 RAID adapter. How should the administrator BEST configure these drives？（）A、Install one drive on the first channel and install the second drive on the second channel.B、Install one drive on the first cable， on the first channel. Install the second drive on the secondcable， on the second channel.C、Install both drives on the same channel. Cable both drives as the primary master on the samecable.D、Install both drives on the same channel. On the same cable one drive should be set as primaryslave and the other drive as the primary master.
A user has recently added a second IDE CD-RW drive to a machine in addition to the primary DVD-ROM drive. The drive opens and closes; however, they do not see it show up in Windows. Which of the following is the MOST likely cause?（）A、The drive jumper settings are incorrect.B、The drive is not receiving power from PSU.C、Windows only supports one optical drive.D、The user connected the drive with a SATA cable.
An administrator needs to add fault tolerance capabilities to a server. Which of the following is the BEST solution to accomplish this？（）A、 Move the architecture from 32-bit to 64-bit.B、 Install a PBX card.C、 Install a second NIC card.D、 Install a fail-over cable.
A server needs to have memory added to support a new application. It currently is using PC4200 in a single channel configuration. Which of the following would be the correct memory upgrade？（）A、Install larger capacity PC2100 dual channel memory modules.B、Add a PCI expansion card with PC2100 single channel memory modules.C、Install smaller capacity PC4200 single channel memory modules.D、Install larger capacity PC4200 single channel memory modules.
Company.com is having trouble installing a fresh AIX image onto a newly defined partition on a p5-520. The assignment of the adapters to the each of the partitions is as follows： Fibre Channel Card 01 - partition one - required Fibre Channel Card 02 - partition one - required SCSI adapter 01 - partition one - desired IDE adapter 01 - partition one - required Ethernet adapter 01 - partition one - required Ethernet adapter 01 - partition two - required SCSI adapter 02 - partition two - required IDE adapter 01 - partition two - desired Which of the following actions will enable the installation of the AIX image？（）A、Change the IDE adapter from desired to required in partition two and restart the partition to release the resource.B、Purchase a SCSI DVD-ROM drive to connect to the SCSI adapter in partition two.C、Purchase an LTO tape drive so that a system image backup can be created to install a new AIX partition.D、Change the IDE adapter from required to desired in partition one and restart the partition to release the resource.
单选题Which of the following is the MAXIMUM theoretical transfer rate of an IDE cable?（）A1.54 MbpsB3.0 GbpsC133 MbpsD480 Mbps
单选题Which of the following settings is the jumper set to when installing a DVD-RW as the second deviceon an IDE cable？（）A ID0B ID2C Cable selectD Master
单选题An administrator is configuring RAID 1 in a server. The administrator has been given two matching 80GB SATA-2 hard drives， two SATA-2 cables， and a SATA-2 RAID adapter. How should the administrator BEST configure these drives？（）AInstall one drive on the first channel and install the second drive on the second channel.BInstall one drive on the first cable， on the first channel. Install the second drive on the secondcable， on the second channel.CInstall both drives on the same channel. Cable both drives as the primary master on the samecable.DInstall both drives on the same channel. On the same cable one drive should be set as primaryslave and the other drive as the primary master.
单选题Which of the following settings is the jumper set to when installing a DVD-RW as the second device on an IDE cable?（）AID0BID2CCable selectDMaster