多选题Which of the following IPv6 tunneling mechanisms support IPv6 IGP routing protocols?()AAutomatic 6to4BManually configured tunnelCISATAPDGRE

多选题
Which of the following IPv6 tunneling mechanisms support IPv6 IGP routing protocols?()
A

Automatic 6to4

B

Manually configured tunnel

C

ISATAP

D

GRE


参考解析

解析: 暂无解析

相关考题:

Which of the following is the IPv6 loopback address?() A.::1B.1.1.1.1C.127.0.0.1D.255.255.255.254

Which of the following IPv6 tunneling mechanisms support IPv6 IGP routing protocols?() A. Automatic 6to4B. Manually configured tunnelC. ISATAPD. GRE

An enterprise has plans to start adding IPv6 support. The initial deployment requires support from some IPv6 - only device s that need to access servers that support only IPv4.Which of the following tools would be most appropriate?()A. Native IPv6B. Point - to -point tunnelsC. Multipoint tunnelsD. NAT - PT

Which command must be globally enabled on a Cisco router to support IPv6?() A. ip routing ipv6B. ipv6 unicast - routingC. ipv6 routingD. ip classlessE. ipv6 cef

Which name describes an IPV6 host-enable tunneling technique that uses IPV4 UDP,does not require dedicated gateway tunnels,and can pass through existing IPV4 NAT gateways?() A.dual stackB.dynamicC.TeredoD.Manual 6to4

What are three IPv6 transition mechanisms?() A.6to4 tunnelingB.VPN tunnelingC.GRE tunnelingD.ISATAP tunnelingE.PPP tunnelingF.Teredo tunneling

When considering the design of the IPv6 address plan for the Enterprise Campus network, whichof the following should serve as guidance?()A、 All the IPv6 subnets should use a /32 prefixB、 Set aside /31 prefixes to support point-to-point links and loopback interfacesC、 The IPv6 address plan should be designed to support the service block model design orintegration with IPv4D、 Designate 16 subnet bits to be split up intelligently, either by OSPF area. VLAN numbering, orIPv4 mapping

Which two tunneling techniques support IPv6 multicasting?()A、6to4B、6over4C、ISATAPD、6PEE、GRE

Which three steps are used to configure IPv6 in JUNOS software?()A、Assign 128-bit router id.B、Enable a routing instance.C、Assign IPv6 addresses to interfaces.D、Add IPv6 family support to interfaces.E、Enable IPv6-capable routing protocol.

Which statement is true concerning 6to4 tunneling?()A、The edge routers can use any locally configured IPv6 address.B、Hosts and routers inside a 6to4 site will need a special code.C、An edge router must use IPv6 address of 2002::/16 in its prefix.D、IPv4 traffic is encapsulated with an IPv6 header.

Which three of these items are IPv6 transition mechanisms? ()(Choose three.)A、ISATAPB、NATV6C、manually configured overlay tunnelsD、dual stack configurations

Which command must be globally enabled on a Cisco router to support IPv6?()A、ip routing ipv6B、ipv6 unicast - routingC、ipv6 routingD、ip classlessE、ipv6 cef

What are three IPv6 transition mechanisms?()A、6to4 tunnelingB、VPN tunnelingC、GRE tunnelingD、ISATAP tunnelingE、PPP tunnelingF、Teredo tunneling

单选题When considering the design of the IPv6 address plan for the Enterprise Campus network, whichof the following should serve as guidance?()A All the IPv6 subnets should use a /32 prefixB Set aside /31 prefixes to support point-to-point links and loopback interfacesC The IPv6 address plan should be designed to support the service block model design orintegration with IPv4D Designate 16 subnet bits to be split up intelligently, either by OSPF area. VLAN numbering, orIPv4 mapping

单选题An enterprise h as plans to start adding IPv6 support. For the first year, the IPv6 will be in small pockets spread around the existing large IPv4 network, with occasional IPv6 traffic while applications teams test IPv6 - enabled servers and applications. Which of the fol lowing tools would be most appropriate?()ANative IPv6BPoint - to -point tunnelsCMultipoint tunnelsDNAT - PT

单选题Which statement is true concerning 6to4 tunneling?()AThe edge routers can use any locally configured IPv6 address.BHosts and routers inside a 6to4 site will need a special code.CAn edge router must use IPv6 address of 2002::/16 in its prefix.DIPv4 traffic is encapsulated with an IPv6 header.

多选题A company is using 6to4 tunneling within their IPv6 network. Which two statements about this kindof tunneling are accurate?()A6to4 is a manual tunnel methodBPrepending a reserved IPv6 code to the hexadecimal representation of 192.168.0.1 facilitates6to4 tunnelingCEach 6to4 site receives a /48 prefix in a 6to4 tunnelD2002::/48 is the address range specifically assigned to 6to4EPrepending 0x2002 with the IPv4 address creates an IPv6 address that is used in 6to4tunneling

单选题A client host uses IPv4 to communicate with one ser ver and IPv6 to communicate with another.Which of the following IPv6 coexistence features is likely at work on the host?()ANative IPv6BPoint - to -point tunnelsCMultipoint tunnelsDNAT - PTEDual stacks

多选题Which three steps are used to configure IPv6 in JUNOS software?()AAssign 128-bit router IDBEnable a routing instance.CAssign IPv6 addresses to interfaces.DAdd IPv6 family support to interfaces

多选题In IPv6 network, an IPv6 overlay tunnel is required to communicate with isolated IPv6 networks across the existing IPv4 infrastructurE. There are currently fiv e IPv6 overlay tunnel types. Which three IPv6 overlay tunnel statements are true?()AOverlay tunnels can only be configured between border routers capable of supporting IPv4 and IPv6.BAn manual overlay tunnel supports point - to - multipo int tunnels capable of carrying IPv6 and Connectionless Network Service (CLNS) packets.COverlay tunneling encapsulates IPv6 packets in IPv4 packets for delivery across an IPv4 infrastructure.DOverlay tunnels can be configured between border route rs or between a border router and a host capable of supporting IPv4 and IPv6.ECisco IOS supports manual, generic routing encapsulation (GRE), IPv4 - compatible, 6to4, and Intra - Site Automatic Tunnel Addressing Protocol (ISATAP) overlay tunneling mechan isms.FCisco IOS supports manual, generic routing encapsulation (GRE), IPv6 - compatible, 4to6, and Multiprotocol Label Switching (MPLS) overlay tunneling mechanisms.

单选题Which name describes an IPV6 host-enable tunneling technique that uses IPV4 UDP,does not require dedicated gateway tunnels,and can pass through existing IPV4 NAT gateways?()Adual stackBdynamicCTeredoDManual 6to4

多选题Which three steps are used to configure IPv6 in JUNOS software?()AAssign 128-bit router id.BEnable a routing instance.CAssign IPv6 addresses to interfaces.DAdd IPv6 family support to interfaces.EEnable IPv6-capable routing protocol.

多选题What are three IPv6 transition mechanisms?()A6to4 tunnelingBVPN tunnelingCGRE tunnelingDISATAP tunnelingEPPP tunnelingFTeredo tunneling

多选题Which two tunneling techniques support IPv6 multicasting?()A6to4B6over4CISATAPD6PEEGRE

单选题An enterprise has plans to start adding IPv6 support. The initial deployment requires support from some IPv6 - only device s that need to access servers that support only IPv4. Which of the following tools would be most appropriate?()ANative IPv6BPoint - to -point tunnelsCMultipoint tunnelsDNAT - PT

单选题Two islands of IPv6 networks that are running ISIS (IPv6 IGP) must be connected using a tunnel over anIPv4 network. Which tunneling method can be used to achieve this goal?()AGRE tunnelsBautomatic 6 to 4 tunnelsCISATAP tunnelsDmanual tunnels (RFC 2893)

多选题Which two tunneling techniques in IPv6 do not require an IPv4 tunnel destination in the configuration?()A6to4B6over4CISATAPDGRE