The following exhibit show s ipv6 route output. What would the metric be for a summary route that summarizes all three OSPFv3 routes displayed?() A. 160B. 140C. 120D. 100
The following exhibit show s ipv6 route output. What would the metric be for a summary route that summarizes all three OSPFv3 routes displayed?()
A. 160
B. 140
C. 120
D. 100
相关考题：
Which statement is correct about the policy shown in the exhibit?() A. All routes are accepted.B. All routes are rejected.C. A 172.27.0.0/24 route will be accepted.D. A 172.27.0.0/16 route will be accepted.
Router R1 lists 4 routes for subnet 10.1.1.0/24 in the output of the show ip eigrp topology all - links command. The variance 200 command is configured, but no other related commands are configured. Which of the following rules are true regarding R1‘s decision of what r outes to add to the IP routing table?Note that RD refers to reported distance and FD to feasible distanc E.（）A. Adds all routes for which the metric is = 200 * the best metric among all routesB. Adds all routes because of the ridiculously high variance settingC. Adds all successor and feasible successor routesD. Adds all successor and feasible successor routes for which the metric is=200 * the best metric among all routes
A network design shows that R1 has four different possible paths from itself to the Data Center subnets.Which one of the following commands is most likely to show you all the possible next - hop IP addresses for these four possible routes?（）A. show ip eigrp topologyB. show ip eigrp topology all - linksC. show ip route eigrpD. show ip route eigrp all - linksE. show ip eigrp topology all - learned
The following exhibit shows ipv6 route output. What would the metric be fo r a summary route that summarizes all three OSPFv3 routes displayed?() A. 160B. 140C. 120D. 100
Refer to the exhibit. Which three statements accurately describe the result of applying the exhibited route map?() A. The map prohibits th e redistribution of all type 2 external OSPF routes.B. All routes that do no match clauses 10 and 20 of the route map are redistributed with their tags set to 8.C. The map prohibits the redistribution of all external OSPF routes with tag 6 set.D. Th e map permits the redistribution of all type 1 external OSPF routes.E. The map redistributes into EIGRP all routes that match the pfx prefix list and the five metric values?0000, 1000, 255, 1, and 1500.F. The map prohibits the redistribution of all ty pe 2 external OSPF routes with tag 6 set.
Refer to the exhibit diagram and config uration. RTB is summarizing its networks from AS 64100 with the aggregate - address command. However, the show ip route command on RTA reveals the RTB individual networks as well as its summary route.Which option would ensure that only the summary route would appear in the routing table of RTA?（）A. Add a static route with a prefix of 192.168.24.0 255.255.252.0 pointing to the null0 interface.B. Create a route map permitting only the summary address.C. Delete the four network statements and leave onl y the aggregate - address statement in the BGP configuration.D. Add the keyword summary - only to the aggregate - address command.
Which three statements are true about EIGRP route summarization?() A.When manual summarization is configured, the router immediately creates a route that points to null0 interfaceB.Manual route summarization is configured in router configuration mode when the router is configured for EIGRP routingC.Manual route summarization is configured on the interfaceD.The ip summary - address eigrp command generates a default route with an administrative distance of 5E.When manual summarization is configured, the summary route will use the metric of the largest specific metric of the summary routesF.The ip summary - address eigrp command generates a default route with an administrative distance of 90
A router has learned three possible routes that could be used to reach a destination network. One route is from EIGRP and has a composite metric of 20514560. Another route is from OSPF with a metric of 782. The last is from RIPv2 and has a metric of 4. Which route or routes will the router install in the routing table?（）A. the OSPF routeB. the EIGRP routeC. the RIPv2 routeD. all three routesE. the OSPF and RIPv2 routes
A router simultaneously receives all the following routes in various routing updates. Which of thefollowing routes would end up in the routing table？（Choose all that apply.）（）A、RIP route 10.1.2.0/24B、EIGRP route 10.1.2.0/24C、RIP route 10.1.0.0/16D、OSPF route 10.1.0.0/16E、RIP route 10.0.0.0/16F、OSPF route 10.1.2.0/24
Which two commands would you use to view OSPF routes?（）A、show ip route ospfB、show ospf routesC、show route protocol ospfD、show route
Router R1 lists 4 routes for subnet 10.1.1.0/24 in the output of the show ip eigrp topology all - links command. The variance 200 command is configured, but no other related commands are configured. Which of the following rules are true regarding R1's decision of what r outes to add to the IP routing table? Note that RD refers to reported distance and FD to feasible distanc E.（）A、Adds all routes for which the metric is = 200 * the best metric among all routesB、Adds all routes because of the ridiculously high variance settingC、Adds all successor and feasible successor routesD、Adds all successor and feasible successor routes for which the metric is=200 * the best metric among all routes
A router has been configured with an EIGRP variance of 3. Which of the following statements istrue？（）A、An error will result because a router cannot be configured with an EIGRP variance of 3 becausethe maximum variance number is 2B、The successor route will end up in the routing table， and so will any route with a metric at mostthree times greater than the value of the successor’s metricC、EIGRP will only advertise routes that are within three hops of the current routerD、The successor route will end up in the routing table， and so will any route with a metric at leastone third the value of the successor’s metricE、The best three routes with equal cost paths will end up in the routing tableF、The successor route will be any route with three times the value of the advertised distance
Which of the following commands shows all routes learned via EIGRP？（Choose all that apply.）（）A、show ip eigrp topologyB、show ip eigrp adjacencyC、show ip eigrp routesD、show ip eigrp databaseE、show ip route eigrpF、show ip eigrp forwarding
Which three statements are true about EIGRP route summarization?（）A、When manual summarization is configured, the router immediately creates a route that points to null0 interfaceB、Manual route summarization is configured in router configuration mode when the router is configured for EIGRP routingC、Manual route summarization is configured on the interfaceD、The ip summary - address eigrp command generates a default route with an administrative distance of 5E、When manual summarization is configured, the summary route will use the metric of the largest specific metric of the summary routesF、The ip summary - address eigrp command generates a default route with an administrative distance of 90
Which three statements are true about EIGRP operation?（）A、When summarization is configured, the router will also create a route to null 0.B、The summary route remains in the route table, even if there are no more specific routes to the network.C、Summarization is configured on a per- interface level.D、The maximum metric for the specific routes is used as the metric for the summary route.E、Automatic summarization across major network boundaries is enabled by default.
Which of the following commands will cause RIPng to originate a default route advertisement whilesuppressing all other routes？（）A、Rl（config-if）#ipv6 default-information originateB、Rl（config-router）#ipv6 rip 〈process-name〉 default-information onlyC、Rl（config）#ipv6 route ：：/0 null 0D、Rl（config-if）#ipv6 rip 〈process-name〉 default-information onlyE、Rl（config-router）#ipv6 rip route ；：/0 originateF、Rl（config-router）#aggregate-address ：：/0 summarize-routes
A router has learned three possible routes that could be used to reach a destination network. One route is from EIGRP and has a composite metric of 20514560. Another route is from OSPF with a metric of 782. The last is from RIPv2 and has a metric of 4. Which route or routes will the router install in the routing table?（）A、the OSPF routeB、the EIGRP routeC、the RIPv2 routeD、all three routesE、the OSPF and RIPv2 routes
A network design shows that R1 has four different possible paths from itself to the Data Center subnets. Which one of the following commands is most likely to show you all the possible next - hop IP addresses for these four possible routes?（）A、show ip eigrp topologyB、show ip eigrp topology all - linksC、show ip route eigrpD、show ip route eigrp all - linksE、show ip eigrp topology all - learned
Which command will display only direct routes?（）A、show routeB、show route inet.0 directC、show ip route directD、show route protocol direct
When attepting to view the OSPF routes in the routing table, you issue the command show route table inet but no OSPF routes are displayed. What is the problem?（）A、The OSPF routes are located in the inet 4 routing tableB、THe OSPF routes are located in the inet 0 routing tableC、The OSPF routes are located in the inet 2 routing tableD、The OSPF routes are located in the inet 4.3 routing table
单选题A router has learned three possible routes that could be used to reach a destination network. One route is from EIGRP and has a composite metric of 20514560. Another route is from OSPF with a metric of 782. The last is from RIPv2 and has a metric of 4. Which route or routes will the router install in the routing table?（）Athe OSPF routeBthe EIGRP routeCthe RIPv2 routeDall three routesEthe OSPF and RIPv2 routes
单选题A router has learned three possible routes that could be used to reach a destination network. One route is from EIGRP and has a composite metric of 20514560. Another route is from OSPF with a metric of 782.The last is from RIPv2 and has a metric of 4. Which route or routes will the router install in the routing table?（）ARouter R2 will not form a neighbor relationship with R1.BRouter R2 will obtain a full routing table, including a default route, from R1.CR2 will obtain OSPF updates from R1, but will not obtain a default route from R1.DR2 will not have a route for the directly connected serial network, but all other directly connected
多选题Refer to the exhibit. Which three statements accurately describe the result of applying the exhibited route map？（）AThe map prohibits the redistribution of all type 2 external OSPF routes with tag 6 setBThe map prohibits the redistribution of all type 2 external OSPF routesCThe map redistributes into EIGRP all routes that match the pfx prefix list and the five metric values40000， 1000， 255， 1， and 1500DThe map prohibits the redistribution of all external OSPF routes with tag 6 setEAll routes that do no match clauses 10 and 20 of the route map are redistributed with their tags set to 8FThe map permits the redistribution of all type 1 external OSPF routes
单选题The fol lowing line of output was extracted from the output of the show ip bgp command on Router R1. Which of the following can be determined from this output?（） Network Next Hop Metric LocPrf Weight Path * 130.1.1.0/28 1.1.1.1 0 1 2 3 4 iAThe route is learne d from an eBGP peerBThe route has no more than three ASNs in the AS_PatHCThe route is the best route for this prefixDNone of these facts can be positively determined by this output
单选题Which of the following commands will cause RIPng to originate a default route advertisement whilesuppressing all other routes？（）ARl（config-if）#ipv6 default-information originateBRl（config-router）#ipv6 rip 〈process-name〉 default-information onlyCRl（config）#ipv6 route ：：/0 null 0DRl（config-if）#ipv6 rip 〈process-name〉 default-information onlyERl（config-router）#ipv6 rip route ；：/0 originateFRl（config-router）#aggregate-address ：：/0 summarize-routes
多选题Process OSPF 1 is redistributing routes from process OSPF 2. Which of the following methods may be used to set the metrics of the redistributed routes?（）ALet the metrics default.BUse each redistributed route's OSPF metric using the redistribute command's metric transparent keywords.CSet the metric using the default - metric router subcommand.DRedistribution is not allowed between two OSPF p rocesses.
多选题A router simultaneously receives all the following routes in various routing updates. Which of thefollowing routes would end up in the routing table？（Choose all that apply.）（）ARIP route 10.1.2.0/24BEIGRP route 10.1.2.0/24CRIP route 10.1.0.0/16DOSPF route 10.1.0.0/16ERIP route 10.0.0.0/16FOSPF route 10.1.2.0/24