An engineer has added the following configuration snippet to an implementation planning document. The configuration will be added to Router R1, whose Fa0/0 interface connects to a LAN to which Routers R2 and R3 also connect. R2 and R3 are already EIGRP neighbors with each of her. Assuming the snippet shows all commands on R1 related to EIGRP authentication, which answer lists an appropriate comment to be made during the implementation plan peer review?()key chain fredkey 3key - string whehewinterface fa0/0ip authenticat ion key - chain eigrp 9 fredA.The configuration is missing one authentication - related configuration commandB.The configuration is missing two authentication - related configuration commandsC.Authentication type 9 is not supported; type 5 should be u sed insteaDD.The key numbers must begin with key 1, so change the key 3 command to key 1

An engineer has added the following configuration snippet to an implementation planning document. The configuration will be added to Router R1, whose Fa0/0 interface connects to a LAN to which Routers R2 and R3 also connect. R2 and R3 are already EIGRP neighbors with each of her. Assuming the snippet shows all commands on R1 related to EIGRP authentication, which answer lists an appropriate comment to be made during the implementation plan peer review?()key chain fredkey 3key - string whehewinterface fa0/0ip authenticat ion key - chain eigrp 9 fred

A.The configuration is missing one authentication - related configuration command

B.The configuration is missing two authentication - related configuration commands

C.Authentication type 9 is not supported; type 5 should be u sed insteaD

D.The key numbers must begin with key 1, so change the key 3 command to key 1


相关考题:

92 Project life cycles provide a better means of measurement of progress and control. The four phases of a project are conceptual development, _____, _____, and _____.A. Preliminary planning, detail planning, closeoutB. Implementation, reporting, terminationC. Development, implementation, terminationD. Execution, reporting, finishingE. Implementation, termination, post-audit review

● Project life cycles provide a better means of measurement of progress and control. The four phases of a project are conceptual development, _____, _____, and _____.A Preliminary planning, detail planning, closeoutB Implementation, reporting, terminationC Development, implementation, terminationD Execution, reporting, finishingE Implementation, termination, post-audit review

All the following tasks involve visual spatial skills EXCEPT ______.A) imagining and handling objectsB) providing a computer with a set of instructionsC) shooting a gun and driving an automobileD) planning and making things as an engineer does

Referring to the exhibit, what are two differences between the active and candidate configurations?() A. The ge-0/0/0 interface was added to the candidate configuration.B. Area 0 was added to the active configuration.C. Area 1 was added to the candidate configuration.D. The ge-0/0/0 interface was added to the active configuration.

Which of the following should an administrator do after running a command from the console onthe perimeter router?() A. Update the configuration logsB. Update the network wiring schematicsC. Update the network configuration proceduresD. Compare the configuration with the baseline

A customer has a Fibre Channel switch residing in a configuration where both production and test data coexist. Which of the following is the simplest method for ensuring that the two types of data do not flow through the same port?()A.VLANB.zoningC.trunkingD.LUN masking

An engineer is reviewing another engineer‘s sample configuration for a GRE tunnel used to pass IPv6 traffiC. The tunnel ha s not yet been configured on the router.Which of the following commands is not required for the configuration to pass IPv6 traffic?()A. tunnel sourceB. tunnel destinationC. tunnel modeD. All these commands are requireD

An engineer is preparing an implementation plan in which the configuration needs to influence BGP‘s choice of best path.Which of the following is least likely to be used by the configuration in this imple mentation plan?()A. WeightB. Origin codeC. AS_PathD. Local_Pref

The following configuration commands exist only in an implementation plan document. An engineer does a copy/paste of these commands into configuration mode on Router R1. Which of the following answers is m ost accurate regarding the results?()ip sla1icmp - echo 1.1.1.1 source -ip 2.2.2.2ip sla schedule 1 start - time now life foreverA. The SLA operation will be configured but will not start until additional commands are usedB. The SLA operation is not comp letely configured so it will not collect any datAC. The SLA operation is complete and working, collecting data into the RTTMON MIBD. The SLA operation is complete and working but will not store the data in the RTTMON MIB without more configuration

An engineer has added the following configuration snippet to an implementation planning document. The configuration will be added to Router R1, whose Fa0/0 interface connects to a LAN to which Routers R2 and R3 also connect. R2 and R3 are already EIGRP neighbors with each of her. Assuming the snippet shows all commands on R1 related to EIGRP authentication, which answer lists an appropriate comment to be made during the implementation plan peer review?() key chain fred key 3 key - string whehew interface fa0/0 ip authenticat ion key - chain eigrp 9 fredA、The configuration is missing one authentication - related configuration commandB、The configuration is missing two authentication - related configuration commandsC、Authentication type 9 is not supported; type 5 should be u sed insteaDD、The key numbers must begin with key 1, so change the key 3 command to key 1

A switch has been configured with two vlans and is connected to a router with a trunk for inter-vlan routing.OSPF has been configured on the router,as the routing protocol for the network.Which statement about thisnetwork is true?()A、For the two vlans to communicate,a network statement for the trunk interface needs to be added to the OSPF configuration.B、For the two vlans to communicate, a network statement for each subinterface needs to be  added  to the OSPF configuration.C、Direct inter-vlan communication does not require OSPFD、OSPF cannot be used if router-on-a-stick is configured on the router

Enterprise Router R1 connects an Enterprise to the Internet. R1 needs to create and advertise a default route into the Enterprise using EIGRP. The engineer creating the implementation plan has chosen to base this default route on the ip route command, rather than using i p default - network. Which of the following is not a useful step with this style of default route configuration?()A、Create the default route on R1 using the ip route 0.0.0.0 0.0.0.0 outgoinginterface command.B、Redistribute the statically configured defa ult route.C、Disable auto - summary.D、Configure the network 0.0.0.0 command.E、Ensure R1 has no manually configured summary routes using the ip summary- address eigrp command.

A customer has a Fibre Channel switch residing in a configuration where both production and test data coexist. Which of the following is the simplest method for ensuring that the two types of data do not flow through the same port?()A、VLANB、zoningC、trunkingD、LUN masking

Router R1 has been configured with the commands rout er eigrp 9 and network 172.16.2.0 0.0.0.255, with no other current EIGRP configuration. R1's (working) Fa0/0 interface has been configured with IP address 172.16.2.2/26. R1 has found three EIGRP neighbors reachable via interface Fa0/0, including the rou ter with IP address 172.16.2.20. When the engineer attempts to add the neighbor 172.16.2.20 fa0/0 command in EIGRP configuration mode. Which of the following occurs?()A、Fa0/0 failsB、The command is rejecteDC、The existing three neighbors failD、The neighborship with 172.16.2.20 fails and then reestablishesE、None of the other answers is correct

The following configuration exists on a router on one end of an IPv6 tunnel. Although the configuration added so far is correct, the configuration is incomplete. Which type of tunnel is most likely to be intended by the network engineer?() interface loopback 1 ip address 192.168.1.1 255.255.255.255 interface tunnel 2 ipv6 address 2002:C0A8:10 1::1/64 tunnel source loopback 1A、Automatic 6to4B、Manually configured tunnelC、ISATAPD、GRE

An engineer is preparing an implementation plan in which the configuration needs to influence BGP's choice of best path. Which of the following is least likely to be used by the configuration in this imple mentation plan?()A、WeightB、Origin codeC、AS_PathD、Local_Pref

Which of these is an accurate list of Cisco Lifecycle Services phases? Select exactly 1 answer(s) from the following:()。A、initiation planning analysis design development implementation operations and maintenanceB、project planning, site assessment risk assessment solution selection and acquisition, testing, and operationsC、prepare, plan, design, implement operate, and optimizeD、analysis, design, deployment testing, implementation, and productionE、presales, project planning, development implementation, operations testing, and operations sign- off

A user’s workstation currently has four connected IDE devices. Which of the following could be added to the workstation to allow more ATA devices to be added to the workstation?()A、Network Interface cardB、Port expansion cardC、Serial interface cardD、Modem card

An administrator has recently added a VLAN to the VIO server and wants to update the documentation. Which command displays the current VIO server VLAN configuration?()A、lsmap -allB、lsmap -netC、lsmap -entD、lsmap -vlan

A customer has an 8-way p5-570 with eight internal disk drives and AIX 5.2.  Which of the following must be added, if anything, to the configuration to support four LPARs, assuming each LPAR requires twodisk drives?()A、7311-D20 drawer with four disksB、Upgrade to AIX 5.3C、Fiber adapters to attach to SAND、Nothing

Company.com with an EtherChannel implementation is considering an HACMP solution. What considerations must be addressed in planning this configuration?()  A、 Hardware address takeover must be configured.B、 IPAT via IP aliasing is required for EtherChannel.C、 EtherChannel must be defined as a separate network.D、 HACMP does not support the fallover of EtherChannel.

You work as an application developer at Certkiller .com. Certkiller .com has instructed you to create a class named MetricFormula. This class will be used to compare MetricUnit and EnglishUnit objects.The MetricFormula is currently defined as follows (Line numbers are used for reference purposes only): 1. public class MetricFormula2. { 3. 4. } You need to ensure that the MetricFormula class can be used to compare the required objects. What should you do? ()A、 Add the following code on line 1: : IComparable {B、 Add the following code on line 1: : IComparer {C、 Add the following code on line 3: public int Compare (object x, object y) {// implementation code }D、 Add the following code on line 3: public int CompareTo (object obj) {// implementation code }

单选题The following configuration commands exist only in an implementation plan document. An engineer does a copy/paste of these commands into configuration mode on Router R1. Which of the following answers is m ost accurate regarding the results?() ip sla 1 icmp - echo 1.1.1.1 source -ip 2.2.2.2 ip sla schedule 1 start - time now life foreverAThe SLA operation will be configured but will not start until additional commands are usedBThe SLA operation is not comp letely configured so it will not collect any datACThe SLA operation is complete and working, collecting data into the RTTMON MIBDThe SLA operation is complete and working but will not store the data in the RTTMON MIB without more configuration

单选题An engineer has added the following configuration snippet to an implementation planning document. The configuration will be added to Router R1, whose Fa0/0 interface connects to a LAN to which Routers R2 and R3 also connect. R2 and R3 are already EIGRP neighbors with each of her. Assuming the snippet shows all commands on R1 related to EIGRP authentication, which answer lists an appropriate comment to be made during the implementation plan peer review?() key chain fred key 3 key - string whehew interface fa0/0 ip authenticat ion key - chain eigrp 9 fredAThe configuration is missing one authentication - related configuration commandBThe configuration is missing two authentication - related configuration commandsCAuthentication type 9 is not supported; type 5 should be u sed insteaDDThe key numbers must begin with key 1, so change the key 3 command to key 1

单选题Which of these is an accurate list of Cisco Lifecycle Services phases? Select exactly 1 answer(s) from the following:()。Ainitiation planning analysis design development implementation operations and maintenanceBproject planning, site assessment risk assessment solution selection and acquisition, testing, and operationsCprepare, plan, design, implement operate, and optimizeDanalysis, design, deployment testing, implementation, and productionEpresales, project planning, development implementation, operations testing, and operations sign- off

单选题Which of the following should an administrator do after running a command from the console onthe perimeter router?()AUpdate the configuration logsBUpdate the network wiring schematicsCUpdate the network configuration proceduresDCompare the configuration with the baseline

多选题An engineer has been told to create an implementation plan to influence the choice of best BGP route on a single router using the Weight featurE. The sole Enterprise Internet - connected router, Ent 1, has neighbor relationships with Routers ISP1 and ISP2, which reside inside two different ISPs. The goal is to prefer all routes learned from ISP1 over ISP2 using Weight. Which of the following answers lists a configuration step that would not be usefu l for achieving these goals?()AConfiguring the neighbor weight command on Ent1.BHaving the ISPs configure the neighbor route - map out command on ISP1 and ISP2, with the route map setting weight.CConfiguring the set weight command inside a route map on Router Ent1.DConfiguring a prefix list to match all class C networks.

单选题An engineer is reviewing another engineer's sample configuration for a GRE tunnel used to pass IPv6 traffiC. The tunnel ha s not yet been configured on the router. Which of the following commands is not required for the configuration to pass IPv6 traffic?()Atunnel sourceBtunnel destinationCtunnel modeDAll these commands are requireD