Refer to the exhibt.Host A has tested connectivity to a remote network.What is the default gateway for host A?() A.172.16.182.1B.192.168.1.1C.10.16.176.1D.192.168.1.6
Refer to the exhibt.Host A has tested connectivity to a remote network.What is the default gateway for host A?()
A.172.16.182.1
B.192.168.1.1
C.10.16.176.1
D.192.168.1.6
相关考题：
How do you verify connectivity between the default gateway and a WX device?() A. Check the WX device remote interface and verify that the status is up.B. From the WX device, ping the default gateway to make sure it is reachable.C. In WebView, check the service tunnel status under Compression Basic Endpoints.D. In WebView, check the remote routes under Compression Advanced Remote Routes.
Refer to the exhibit.The network administrator normally establishes a telnet session with the switch from host A.However,host A is unavailable.The administrators attempt to the switch from host B fails,but pings to the other two hosts are successful.what is the issue?（）A.Host B and the switch need to be in the same subnet.B.The switch needs and appropriate default gateway assigned.C.The switch interface connected to the router is down.D.Host B need to be assigned an IP address in vlan 1.E.The switch interfaces need the appropriate IP addresses assigned.
Refer to the exhibit. Which value will be configured for Default Gateway of the Local Area Connection?() A.10.0.0.0B.10.0.0.254C.192.223.129.0D.192.223.129.254
While troubleshooting a connectivity issue from a PC you obtain the following information: Local PC IP address: 190.0.3.35/24 Default Gateway: 190.0.3.1 Remote Server: 190.0.5.250/24 You then conduct the following tests from the local PC: Ping 127.0.0.1 - Unsuccessful Ping 190.0.3.35 - Successful Ping 190.0.3.1 - Unsuccessful Ping 190.0.5.250 - Unsuccessful What is the underlying cause of this problem?（）A、TCP/IP not correctly installedB、Local physical layer problemC、NIC not functioningD、Remote physical layer problem
While troubleshooting a connectivity issue from a PC you obtain the following information: Local PC IP address: 10.0.0.35/24 Default Gateway: 10.0.0.1 Remote Sever: 10.5.75.250/24 You then conduct the following tests from the local PC: Ping 127.0.0.1 – Successful Ping 10.0.0.35 – Successful Ping 10.0.0.1 – Unsuccessful Ping 10.5.75.250 – Unsuccessful What is the underlying cause of this problem?（）A、A remote physical layer problem exists.B、The host NIC is not functioning.C、TCP/IP has not been correctly installed on the host.D、A local physical layer problem exists.
Refer to the exhibt.Host A has tested connectivity to a remote network.What is the default gateway for host A?（）A、172.16.182.1B、192.168.1.1C、10.16.176.1D、192.168.1.6
A network host is configured as follows: Host IP address: 192.168.16.183 Subnet mask: 255.255.255.224 Default gateway: 192.168.16.190 Which of the following statements describe the network to which this host is attached?（）A、The default gateway is configured on a different subnet form this host.B、The host is a member of the fifth usable subnet of the 192.168.16.0 network.C、The subnetwork address for this host is 192.168.16.160/28.D、The address of the next higher subnet is 192.168.16.192.E、The address of the router interface that is attached to this subnetwork is 192.168.16.190.F、There are 60 usable host addresses on this subnet.
For a technician to test network connectivity to a remote host on a Unix Server which of the following commands should they run？（）A、 IPCONFIGB、 PINGC、 ARPD、 IFCONFIG
You are a systems administrator and you are about to assign static IP addresses to various servers on your network. For the network 192.168.20.24/29 the router is assigned to the first usable host address, while the last usable host address goes to your Sales server. Which one of the following commands would you enter into the IP properties box of the sales server?（）A、IP address: 192.168.20.14 Subnet Mask: 255.255.255.248 Default Gateway:192.168.20.9B、IP address: 192.168.20.254 Subnet Mask: 255.255.255.0 Default Gateway:192.168.20.1C、IP address: 192.168.20.30 Subnet Mask 255.255.255.248 Default Gateway:192.168.20.25D、IP address: 192.168.20.30 Subnet Mask 255.255.255.240 Default Gateway:192.168.20.17E、IP address: 192.168.20.30 Subnet Mask 255.255.255.240 Default Gateway:192.168.20.25
An administrator issues the command ping 127.0.0.1 from the command line prompt on a PC. If a reply is received, what does this confirm（）。A、The PC has connectivity with a local host.B、The PC has connectivity with a Layer 3 device.C、The PC has a default gateway correctly configured.D、The PC has connectivity up to Layer 5 of the OSI model.E、The PC has the TCP/IP protocol stack correctly installed.
An administrator issues the command ping 127.0.0.1 from the command line prompt on a PC.If a reply is received, what does this confirm?（）A、The PC has connectivity with a local host.B、The PC has connectivity with a Layer 3 device.C、The PC has a default gateway correctly configuredD、The PC has connectivity up to Layer 5 of the OSI modelE、The PC has the TCP/IP protocol stack correctly installed.
A technician is troubleshooting a host connectivity problem. The host is unable to ping a server connected to Switch_A. Based on the results of the testing, what could be the problem（）。A、A remote physical layer problem exists.B、The host NIC is not functioning.C、TCP/IP has not been correctly installed on the host.D、A local physical layer problem exists.
Two sites are using a multisite centralized call processing model. The voice gateway on the remote branch has lost IP connectivity to its Cisco CallManager server. Which feature enables the remote gateway to take the role of the call agent during the WAN failure？ （）A、automated alternate routing （AAR）B、Cisco CallManager Attendant ConsoleC、real-time protocol （RTP）D、Survivable Remote Site Telephony （SRST）
The sysdumpdev command can be used to configure remote dump devices. Which of the following conditions is NOT used for a remote dump device configuration?（）A、The local and the remote host must have Transmission Control Protocol/Internet Protocol (TCP/IP) installed and configured. B、The remote host must support NFS. C、The remote host must have an NFS exported directory defined such that the local host has read and write permissions to the dump file on the remote host. D、The remote host can be the same as the local host.
Your company has a load-balanced Remote Desktop Session Host （RD Session Host） cluster. You are configuring the Remote Desktop Gateway （RD Gateway） role service on servers that run Windows Server 2008 R2. You need to centralize the storage of Remote Desktop connection authorization policies （RD CAPs）. Which two actions should you perform？（）A、Install the Network Policy Server role service.B、Install the Distributed File System role service.C、Configure the RD Gateway servers to use a local RD CAP store.D、Configure the RD Gateway servers to use a remote RD CAP store.
Your company has an Active Directory Domain Services (AD DS) domain. All servers run Windows Server 2008 R2. All client computers run Windows 7. You have a Remote Desktop Session Host (RD Session Host) server and a Remote Desktop Gateway (RD Gateway) server. You use Windows Firewall on your servers. You need to ensure that users can connect to their virtual desktops. What should you do？（）A、Create a Windows Firewall inbound rule for port 443 on the RD Gateway server.B、Create a Windows Firewall inbound rule for port 443 on the RD Session Host server.C、Create a Windows Firewall inbound rule for port 3389 on the RD Gateway server.D、Create a Windows Firewall inbound rule for port 3389 on the RD Session Host server.
单选题Refer to the exhibt.Host A has tested connectivity to a remote network.What is the default gateway for host A?（）A172.16.182.1B192.168.1.1C10.16.176.1D192.168.1.6
单选题A technician is troubleshooting a host connectivity problem. The host is unable to ping a server connected to Switch_A. Based on the results of the testing, what could be the problem（）。AA remote physical layer problem exists.BThe host NIC is not functioning.CTCP/IP has not been correctly installed on the host.DA local physical layer problem exists.
单选题While troubleshooting a connectivity issue from a PC you obtain the following information: Local PC IP address: 10.0.0.35/24 Default Gateway: 10.0.0.1 Remote Sever: 10.5.75.250/24 You then conduct the following tests from the local PC: Ping 127.0.0.1 – Successful Ping 10.0.0.35 – Successful Ping 10.0.0.1 – Unsuccessful Ping 10.5.75.250 – Unsuccessful What is the underlying cause of this problem?（）AA remote physical layer problem exists.BThe host NIC is not functioning.CTCP/IP has not been correctly installed on the host.DA local physical layer problem exists.
单选题An administrator issues the command ping 127.0.0.1 from the command line prompt on a PC. If a reply is received, what does this confirm（）。AThe PC has connectivity with a local host.BThe PC has connectivity with a Layer 3 device.CThe PC has a default gateway correctly configured.DThe PC has connectivity up to Layer 5 of the OSI model.EThe PC has the TCP/IP protocol stack correctly installed.
单选题An administrator must assign static IP addresses to the servers in a network.For network 192.168.20.24/29, the router is assigned the first usable host address while the sales server is given the last usable host address. Which of the following should be entered into the IP propertied box for the sales server?（）AIP address:192.168.20.14 Subnet Mask:255.255.255.248 Default Gateway:192.168.20.9BIP address:192.168.20.254 Subnet Mask:255.255.255.0 Default Gateway:192.168.20.1CIP address:192.168.20.30 Subnet Mask:255.255.255.248 Default Gateway:192.168.20.25DIP address:192.168.20.30 Subnet Mask:255.255.255.240 Default Gateway:192.168.20.17EIP address:192.168.20.30 Subnet Mask:255.255.255.240 Default Gateway:192.168.20.25
单选题How do you verify connectivity between the default gateway and a WX device?（）ACheck the WX device remote interface and verify that the status is up.BFrom the WX device, ping the default gateway to make sure it is reachable.CIn WebView, check the service tunnel status under Compression Basic Endpoints.DIn WebView, check the remote routes under Compression Advanced Remote Routes.
单选题Your company has an Active Directory Domain Services (AD DS) domain. All servers run Windows Server 2008 R2. All client computers run Windows 7. Remote client computers are not members of the domain. Your environment includes a Remote Desktop Gateway (RD Gateway) server. You install an application on a Remote Desktop Session Host (RD Session Host) server. You need to ensure that remote users can run the application. What should you do？（）AOn each remote client computer, configure the Remote Desktop Connection client to connect to the RD Gateway server.BOn each remote client computer, configure the Remote Desktop Connection client to connect without warning if server authe ntication fails.COn the RD Session Host server, configure the Remote Desktop Connection client to connect to the RD Gateway server.DOn the RD Gateway server, add the Guests local group to the Remote Desktop Users local group.
多选题A network host is configured as follows: Host IP address: 192.168.16.183 Subnet mask: 255.255.255.224 Default gateway: 192.168.16.190 Which of the following statements describe the network to which this host is attached?（）AThe default gateway is configured on a different subnet form this host.BThe host is a member of the fifth usable subnet of the 192.168.16.0 network.CThe subnetwork address for this host is 192.168.16.160/28.DThe address of the next higher subnet is 192.168.16.192.EThe address of the router interface that is attached to this subnetwork is 192.168.16.190.FThere are 60 usable host addresses on this subnet.