An administrator has just upgraded a server from non-hot plug storage to all hot plug storage. The administrator powers up the server, during POST the RAID controller is recognized but none of the drive lights flash. Which of the following should the administrator do FIRST to troubleshoot the problem?()A、Check the backplane cabling.B、Check the server BIOS.C、Update the RAID controller firmware.D、Install the latest hard drive firmware

An administrator has just upgraded a server from non-hot plug storage to all hot plug storage. The administrator powers up the server, during POST the RAID controller is recognized but none of the drive lights flash. Which of the following should the administrator do FIRST to troubleshoot the problem?()

  • A、Check the backplane cabling.
  • B、Check the server BIOS.
  • C、Update the RAID controller firmware.
  • D、Install the latest hard drive firmware

相关考题:

Unluckily, when I dropped in , Dr. Smith (), so we only had time for a few words. A、just leftB、was just leavingC、has just leftD、had just left

An administrator has just installed a new NIC into the server. The system POSTs fine and the NIC is recognized by the OS, but it does not receive an IP address. Which of the following is the MOST likely cause of this?()A. The NIC is not on the HCL.B. The driver is incorrect on the server.C. The patch cable has not been seated properly.D. The NIC is not seated properly.

An administrator has just upgraded a server from non-hot plug storage to all hot plug storage. The administrator powers up the server, during POST the RAID controller is recognized but none of the drive lights flash.Which of the following should the administrator do FIRST to troubleshoot the problem?()A. Check the backplane cabling.B. Check the server BIOS.C. Update the RAID controller firmware.D. Install the latest hard drive firmware

A system administrator has just applied an update to an AIX system to correct a problem, The APAR number is IX49035 and was shipped as part of the PTF number U437542. After applying the APAR fix, the administrator wants to ensure that the fix is applied before informing the system users of the corrected problem. Which of the following commands should the system administrator run to verify that the APAR fix has been applied to the system?()A.lslpp -f IX49035B.lslpp -fB U437542C.instfix -f IX49035D.instfix -ik IX49035

Today is Jenny’s wedding day.She_______to Thomas.A.just has got marriedB.has just marriedC.was just marriedD.has just got married

An administrator has added a new device to a system and wants to determine if it has been correctly added to the ODM database. Which command would the system administrator use?()A、odmgetB、odmaddC、odmshowD、odmcreate

An administrator has just installed a new NIC into the server. The system POSTs fine and the NIC is recognized by the OS, but it does not receive an IP address. Which of the following is the MOST likely cause of this?()A、The NIC is not on the HCL.B、The driver is incorrect on the server.C、The patch cable has not been seated properly.D、The NIC is not seated properly.

An administrator has just finished physically replacing the system board in a Windows domain controller. Which of the following must be done before booting the server back into Windows?()A、Update the time and date in the BIOS.B、Update the firmware on the SCSI controller.C、Update the firmware to the latest version.D、Configure IPMI on the new board.

The administrator has just installed a new memory module into the server. Now, the server is not showing the new memory. Which of the following should the administrator perform FIRST?()A、System rebootB、Reseat the memoryC、Install the latest firmwareD、Install the latest driver

An administrator has just installed a web server for the companys Internet site. After bringing the system online, customers notify the administrator that they cannot connect to the server. The administrator tests the web server from a workstation and can access the website. The customers continue to report issues.  Which of the following is the MOST likely reason for this?()A、 The servers firewall is misconfigured.B、 The server’s timeout feature is set incorrectly.C、 The web server was not installed properly.D、 The company firewall is misconfigured.

The server administrator has just brought a new Windows server online. Permissions are set, but the server administrator cannot connect remotely. Which of the following is MOST likely the problem?()A、WMI was not enabled.B、Server service was not enabled.C、RDP was not enabled.D、Workstation service was not enabled.

The server room that an administrator manages has just caught fire. Which of the following is the FIRST thing that the administrator should do?()A、 Evacuate all personnel.B、 Notify staff of the potential service outage.C、 Use fire suppression techniques until the fire department arrives.D、 Grab the backup tapes and exit the server room.

A System p administrator has just configured logging system messages with the syslogd daemon.  At boot time which file starts the syslog daemon()A、/etc/rc.tcpipB、/sbin/rc.bootC、/etc/rc.netD、/etc/rc.d

An administrator has a two-disk volume group (testvg) with one logical volume (testlv) which has just  been mirrored across both disk drives.  Which of the following commands can be used to turn off quorum()A、chvg -Qn testvgB、chlv -Qn testvgC、varyoffvg testvg; varyonvg -Qn testvgD、varyoffvg testvg; exportvg testvg; importvg -Qn testvg; varyonvg testvg

A system administrator has just installed a new maintenance level, but "oslevel -r" does not show the correct maintenance level. What command can be used to determine which filesets are downlevel?()A、lppchkB、instfixC、fixdistD、maintlvl

A system administrator has just finished upgrading a system to AIX 5.2. If there are future problems, the system administrator would like to add an entry to the AIX errorlog to record this event. Which of the following commands can be issued for this purpose?()A、/usr/bin/errmsg "System upgraded to AIX 5.2"B、/usr/bin/errlog "System upgraded to AIX 5.2"C、/usr/bin/errupdate "System upgraded to AIX 5.2"D、/usr/bin/errlogger "System upgraded to AIX 5.2"

A System p administrator has just installed a new technology level, but "oslevel -r" does not show the expected technology level.  Which of the following commands would determine which filesets are downlevel()A、lppchkB、instfixC、oslevelD、installp

An administrator has mirrored the root volume group to a second disk, but ’bootlist’ is failing to correctly add the second disk.  What is the likely cause of the problem?()  A、The administrator has failed to run ’bosboot -ad 2nd disk’ prior to the bootlist command.B、The administrator has failed to run ’bootinfo -B 2nd disk’ prior to the bootlist command.C、The administrator has failed to run ’mirrorvg -m rootvg 2nd disk’ prior to the bootlist command.D、The administrator has failed to run ’bosboot -ad /dev/ipldevice 2nd disk’ prior to the bootlist command.

A system administrator has just applied an update to an AIX system to correct a problem, The APAR number is IX49035 and was shipped as part of the PTF number U437542. After applying the APAR fix, the administrator wants to ensure that the fix is applied before informing the system users of the corrected problem. Which of the following commands should the system administrator run to verify that the APAR fix has been applied to the system?()A、lslpp -f IX49035B、lslpp -fB U437542C、instfix -f IX49035D、instfix -ik IX49035

单选题The server room that an administrator manages has just caught fire. Which of the following is the FIRST thing that the administrator should do?()A Evacuate all personnel.B Notify staff of the potential service outage.C Use fire suppression techniques until the fire department arrives.D Grab the backup tapes and exit the server room.

单选题A System p administrator has just configured logging system messages with the syslogd daemon.  At boot time which file starts the syslog daemon()A/etc/rc.tcpipB/sbin/rc.bootC/etc/rc.netD/etc/rc.d

单选题An administrator has just installed a web server for the company's Internet site. After bringing the system online, customers notify the administrator that they cannot connect to the server. The administrator tests the web server from a workstation and can access the website. The customers continue to report issues. Which of the following is the MOST likely reason for this?()AThe server's firewall is misconfigured.BThe server's timeout feature is set incorrectly.CThe web server was not installed properly.DThe company firewall is misconfigured.

单选题An administrator has just installed a new NIC into the server. The system POSTs fine and the NIC is recognized by the OS, but it does not receive an IP address. Which of the following is the MOST likely cause of this?()AThe NIC is not on the HCL.BThe driver is incorrect on the server.CThe patch cable has not been seated properly.DThe NIC is not seated properly.

单选题An administrator has just upgraded a server from non-hot plug storage to all hot plug storage. The administrator powers up the server, during POST the RAID controller is recognized but none of the drive lights flash. Which of the following should the administrator do FIRST to troubleshoot the problem?()ACheck the backplane cabling.BCheck the server BIOS.CUpdate the RAID controller firmware.DInstall the latest hard drive firmware

单选题An administrator has mirrored the root volume group to a second disk, but ’bootlist’ is failing to correctly add the second disk.  What is the likely cause of the problem?()AThe administrator has failed to run ’bosboot -ad 2nd disk’ prior to the bootlist command.BThe administrator has failed to run ’bootinfo -B 2nd disk’ prior to the bootlist command.CThe administrator has failed to run ’mirrorvg -m rootvg 2nd disk’ prior to the bootlist command.DThe administrator has failed to run ’bosboot -ad /dev/ipldevice 2nd disk’ prior to the bootlist command.