Which statement describe two of the benefits of VLAN Trunking Protocol?（）A、VTP allows routing between VLANs.B、VTP allows a single switch port to carry information to more than one VLAN.C、VTP allows physically redundant links while preventing switching loops.D、VTP simplifies switch administration by allowing switches to automatically share VLAN configuration information.E、VTP helps to limit configuration errors by keeping VLAN naming consistent across the VTP domain.F、VTP enhances security by preventing unauthorized hosts from connecting to the VTP domain.
Which statement describe two of the benefits of VLAN Trunking Protocol?（）
- A、VTP allows routing between VLANs.
- B、VTP allows a single switch port to carry information to more than one VLAN.
- C、VTP allows physically redundant links while preventing switching loops.
- D、VTP simplifies switch administration by allowing switches to automatically share VLAN configuration information.
- E、VTP helps to limit configuration errors by keeping VLAN naming consistent across the VTP domain.
- F、VTP enhances security by preventing unauthorized hosts from connecting to the VTP domain.
相关考题：
Which one is not the feature of the Cisco Unified Wireless Network architecture？（）A、 network unificationB、 remote accessC、 mobility servicesD、 network management
A Cisco 4404 WLAN controller is being connected to a Cisco 6500 Catalyst Series Switch. How would you interconnect and configure LAG for connectivity and ensure redundancy？（）A、All four ports from the Cisco WLC terminated to the same Catalyst gigabit module and channelgroup.B、Ports 1 and 2 from Cisco WLC to Catalyst gigabit module slot 1 channel group 10 and CiscoWLC ports3 and 4 to Catalyst gigabit module slot 2 channel group 10.C、All four ports from the Cisco WLC terminated to the same Catalyst gigabit module using two channel groups.D、Ports 1 and 2 from Cisco WLC to Catalyst gigabit module slot 1 channel group 20 and CiscoWLC ports 3 and 4 to Catalyst gigabit module slot 2 channel group 40.
Which three technologies are used to reduce chromatic dispersion accumulation in fiber-optic transmission systems？（）A、 PIN photodiodesB、 zero-chirped lasersC、 Erbium-doped fiber amplifiersD、 dispersion compensating fiberE、 dispersion compensating Bragg grating
A request arrived on your MPLS-vpn-bgp group. Due to a security breach，your customer is experiencing DoS attacks coming from specific subnets （200.0.10.0/24， 200.0.12.0/24）. You have checked all MPLS-EBGP routes being advertised to BHK from other VPN sites and found four subnets listed：200.0.10.0/24，200.0.11.0/24，200.0.12.0/24，200.0.13.0/24. You immediately apply an outbound ACL filter using the appropriate MPLS-EBGP tool： access-list 1 deny 0.0.0.0 255.255.254.255 access-list 1 permit any What happens when you apply this ACL on the MPLS-EBGP connection to BHK？（）A、It blocks all routes.B、It blocks the routes 200.0.12.0/24，200.0.10.0/24 only.C、It blocks the routes 200.0.12.0/24，200.0.13.0/24 only.D、It blocks the routes 200.0.10.0/24，200.0.13.0/24 only.E、Nothing happens，no routes are blocked.
Which Cisco IOS command is used to troubleshoot a problem in which a BGP session stays in the active state?（）A、debug ip bgp updatesB、debug ip tcp eventsC、debug ip bgp transactionsD、debug ip tcp transactions
What are some characteristics of the typical VLAN arrangement?（）A、VLANs logically divide a switch into multiple, independent switches at Layer 2.B、Trunk links can carry traffic for multiple VLANs.C、VLAN implementation significantly increases traffic due to added trunking information.D、A VLAN can span multiple switches.E、VLANs extend the collision domain to include multiple switches.F、VLANs typically decrease the number of multiple switches.
Which two design recommendations are most appropriate when OSPF is the data center core routing protocol？ （）A、 Never use passive interfaces.B、 Use NSSA areas from the core down.C、 Use totally stub areas to stop type 3 LSAs.D、 Use the lowest Ethernet interface IP address as the router ID.E、 Tune OSPF timers to enable OSPF to achieve quicker convergence
Which implement phase service component describes the activities to install and test your Cisco Unified Communications solution in a nonproduction lab environment（）A、Proof of ConceptB、Acceptance TestingC、StagingD、Lab Testing
在路由器上配置帧中继静态map必须指定（）参数。A、本地的DLCIB、对端的DLCIC、本地的协议地址D、对端的协议地址