VRP平台上,设置Serial接口数据链路层的封装类型为HDLC的命令是()。A.encapsulation hdlcB.link-protocol hdlcC.hdlc enableD.link-protocol ppp
VRP平台上,设置Serial接口数据链路层的封装类型为HDLC的命令是()。
A.encapsulation hdlc
B.link-protocol hdlc
C.hdlc enable
D.link-protocol ppp
相关考题:
接口状态为“administrativelydown,lineprotocoldown”的原因是什么?() A.有一个在封装类型不匹配B.错误类型的电缆被连接到接口C.该接口已经配置了shutdown命令D.接口没有收到任何保活报文E.接口需要配置为DTE设备F.没有配置封装类型
设置接口的链路层协议为X.25,并指定其工作方式为DTE的命令是(). A.[RouterA-Serial1/0/0] link-protocol x25dceB.[RouterA-Serial1/0/0] link-protocol x.25dceC.[RouterA-Serial1/0/0] link-protocol x25dteD.[RouterA-Serial1/0/0] link-protocol x.25dte
VRP平台上,在Serial口上设置数据链路层封装类型为HDLC的命令是(). A.encapsulation hdlcB.link-protocol hdlcC.hdlc enableD.link-protocolppp
2、【STCS_03_2】设置接口链路层协议为HDLC的命令为:A.Router(config)#encapsulation hdlcB.Router#encapsulation hdlcC.Router(config-if)#encapsulation hdlcD.Router(config-if)#show interface 端口号
VRP平台上,设置Serial接口数据链路层的封装类型为HDLC的命令是()。A.encapsulation hdlc B.link-protocol hdlc C.hdlc enable D.link-protocol ppp
下列关于HDLC的说法哪个是错误的()?A.HDLC是面向比特的链路层协议,其传输的数据必须是规定字符集 B.HDLC运行于同步串行线路C.链路层封装标准HDLC协议的单一链路只能承载单一的网络层协议D.HDLC是面向字符的链路层协议,其传输的数据必须是规定字符集
1、【STCS_03_2】设置接口链路层协议为HDLC的命令为:A.Router(config)#encapsulation hdlcB.Router#encapsulation hdlcC.Router(config-if)#encapsulation hdlcD.Router(config-if)#show interface 端口号