在思科路由器上，应该使用什么命令来观察网络的路由表（）A、Show ip pathB、Show ip routeC、Show interfaceD、Show running-config
在思科路由器上，应该使用什么命令来观察网络的路由表（）
- A、Show ip path
- B、Show ip route
- C、Show interface
- D、Show running-config
相关考题：
下面哪条命令能现实路由器所知道的路由,以及他们各自是如何学习到的?() A.Show ip protocolB.Show ip routeC.Show ip ospfD.Show ip ospf neighbor
Which command is used to display the placement and direction of an IP access control list on a router?() A. show access-listB. show ip routeC. show ip interfaceD. show interfaceE. show interface listF. show ip interface brief
Which one of the following commands will display the placement and direction of an IP access control list on the interfaces of a router?() A. show interface listB. show ip routeC. show ip interfaceD. show ip interface briefE. show interface
在路由器上使用______命令查看路由表。A．display ip routing-tableB．show routing-tableC．show ip routeD．route print
查看静态NAT映射条目的命令为（）A、show ip interfaceB、show ip nat routeC、show ip nat statisticsD、show nat ip statistics
在华为路由器上，应该使用什么命令来观察网络的路由表？（）A、show ip pathB、display ip routing-tableC、display interfaceD、display running-configE、Show ip rip
要确定区域内放置的接口是否正确，应使用下列哪一个命令？（）A、show ip ospfB、show ospf interfaceC、show ip interfaceD、show ip ospf interfaceE、show interface
下面哪条命令能现实路由器所知道的路由，以及他们各自是如何学习到的？（）A、Show ip protocolB、Show ip routeC、Show ip ospfD、Show ip ospf neighbor
要查看一个Cisco路由器接口上是否有某些ACL，你该使用命令（）A、show running－config;B、show ip protocols;C、show ip interface;D、show ip network。
在路由器上进行ACL故障排查时，（）命令能用来确定ACL是否影响了哪些接口。A、show ip access-listB、show access-listC、list ip interfaceD、show ip interface
在Quidway路由器上，应该使用什么命令来观察网络的路由表？（）A、DISPLAY ip pathB、DISPLAY ip routeC、DISPLAY interfaceD、DISPLAY running-configE、DISPLAY ip rip
Which one of the following commands will display the placement and direction of an IP access control list on the interfaces of a router?（）A、show interface listB、show ip routeC、show ip interfaceD、show ip interface briefE、show interface
Which command is used to display the placement and direction of an IP access control list on a router?（）A、show access-listB、show ip routeC、show ip interfaceD、show interfaceE、show interface listF、show ip interface brief
Which command would display OSPF parameters such as filters， default metric， maximum paths，and number of areas configured on a router？（）A、show ip protocolB、show ip routeC、show ip ospf interfaceD、show ip ospfE、show ip interfaceF、None of the other alternatives apply
检查路由器接口好坏使用（）命令。A、reloadB、show ip routeC、pingD、show interface