You want to allow your device to establish OSPF adjacencies with a neighboring device connected tointerface ge-0/0/3.0. Interface ge-0/0/3.0 is a member of the HR zone.Under which configuration hierarchy must you permit OSPF traffic？（）A、[edit security policies from-zone HR to-zone HR]B、[edit security zones functional-zone management protocols]C、[edit security zones protocol-zone HR host-inbound-traffic]D、[edit security zones security-zone HR host-inbound-traffic protocols]
You want to allow your device to establish OSPF adjacencies with a neighboring device connected tointerface ge-0/0/3.0. Interface ge-0/0/3.0 is a member of the HR zone.Under which configuration hierarchy must you permit OSPF traffic？（）
- A、[edit security policies from-zone HR to-zone HR]
- B、[edit security zones functional-zone management protocols]
- C、[edit security zones protocol-zone HR host-inbound-traffic]
- D、[edit security zones security-zone HR host-inbound-traffic protocols]
相关考题：
A router receives an IPv6 packet which is 2000 bytes in length. The MTU of the outgoing interface is 1500 bytes. What action will the router take？（）A、forwards the packetB、fragments the packetC、drops the packet silentlyD、drops the packet and sends an ICMP message
You have been allocated a /22 network.How many usable hosts are available?（）A、510B、512C、1022D、1024
Which two statements accurately describe an IBGP peering session?（） (Choose two.)A、Peers are statically defined.B、Peers exist within the same AS.C、Peers must be directly connected to each other.D、Peers advertise routes learned from other IBGP neighbors.
You want to configure a single EBGP peering session over parallel physical circuits. Which BGPfeature enables load balancing in this scenario?（）A、multihop BGPB、multicast BGPC、route reflectionD、multiprotocol BGP
When is the BA Classifier engaged for identifying the forwarding class of traffic in a Juniper router?（）A、after a packet is identified by a multifield classifierB、after the traffic passes though a shaperC、prior to ingress policing of trafficD、while the packet is stored in the switching fabric of the router
Which two statements are true about the primary address on an interface? （）A、It is the address used by default as the local address for broadcast and multicast packets sourced locally and sent out of the interfaceB、You use the primary address when you have multiple IP addresses belonging to the same subnet on the same intefaceC、It can be useful for selecting the local address used for packets sent out of unnumbered interfaces when multiple non-127 addresses are configured on the loopback interfaceD、By default, the primary address on an interface is selected as the nmerically highest local address configured on the interface
Which CLI command displays packet and byte counts for an interface in real-time?（）A、monitor trafficB、show interfacesC、monitor interfaceD、show traffic counts