单选题A technician notices that when trying to ping a workstation by network name the workstation does not reply back over the network. The workstation is part of the domain and is able to get to the Internet. Which of the following is the cause of the problem？（）AFaulty cable on the workstationBWrong host name on the workstationCWrong WINS on the workstationDIncorrect IP address assigned to the workstation
单选题
A technician notices that when trying to ping a workstation by network name the workstation does not reply back over the network. The workstation is part of the domain and is able to get to the Internet. Which of the following is the cause of the problem？（）
A
Faulty cable on the workstation
B
Wrong host name on the workstation
C
Wrong WINS on the workstation
D
Incorrect IP address assigned to the workstation
参考解析
解析：
暂无解析
相关考题：
While troubleshooting a network connectivity problem, a Ezonexam technician observes steady link lights on both the workstation NIC and the switch port to which the workstation is connected. However, when the ping command is issued from the workstation, the output message "Request timed out." is displayed. At which layer of the 7-layer OSI model does the problem most likely exist?A. The data link layerB. The application layerC. The protocol layerD. The access layerE. The session layerF. The network layerG. None of the above
The technician notices that one of the wires in a CAT5 cable is cut in half. Which of the followingconnectivity issues did the technician discover?() A.Open pairsB.AttenuationC.CrosstalkD.Interference
A network technician wants to use a packet analyzer to troubleshoot a reported problem with auser‘s workstation with IP address 192.168.1.45. To identify the workstation‘s packets thetechnician wants to use the workstation‘s MAC address.Which of the following protocols would provide the needed information?（）A.DHCPB.ARPC.DNSD.PING
A technician is troubleshooting a network connectivity issue on a MFD and would like to eliminate the possibility of another device on the network having the same IP address. The technician should：（）A、disconnect the MFD and ping the IP address.B、disconnect the MFD and ping the subnet mask.C、disconnect the MFD and ping the loopback address.D、run the ipconfig command from the command prompt.
You work as a network Technician. A new workstation has consistently been unable to obtain anIP address from the DHCP server when the workstation boots. Older workstations function normally， and the new workstation obtains an address when manually forced to renew its address. What should be configured on the switch to allow the workstation to obtain an IP address at boot？（）A、UplinkFast on the switch port connected to the serverB、BackboneFast on the switch port connected to the serverC、PortFast on the switch port connected to the workstationD、trunking on the switch
Which of the following should a technician do FIRST to troubleshoot a users network connectivity problem？（）A、Run TRACERT from the users workstation.B、Start with the Last Known Good Configuration and reboot the computer.C、Replace the network interface card （NIC）.D、PING the users workstation.
A technician is attempting to use a command line prompt to continuously ping a remote server to check availability and reliability of the connection. Which of the following provides the ping command needed to continuously ping the system?（）A、ping -aB、ping -fC、ping -rD、ping -t
While troubleshooting a network connectivity problem, a technician observes steady link lights on both the workstation NIC and the switch port to which the workstation is connected. However, when the ping command is issued from the workstation, the output message "Request timed out." is displayed. At which layer of the OSI model does the problem most likely exist（）。A、the session layerB、the protocol layerC、the data link layerD、the access layerE、the network layerF、the application layer
A network technician wants to use a packet analyzer to troubleshoot a reported problem with a user's workstation with IP address 192.168.1.45. To identify the workstation's packets the technician wants to use the workstation's MAC address. Which of the following protocols would provide the needed information?（）A、DHCPB、ARPC、DNSD、PING
Which of the following ping commands would a technician use to ping continuously?（）A、PING -lB、PING -RC、PING -tD、PING -a
Mike, a technician, is working on several workstations and needs to continuously investigatesystems so he knows when the workstations reboot. Which of the following commands could beused?（）A、ping -l 9999B、tracert -dC、ping -tD、tracert -h 9999
Which of the following commands should Jill, a technician, use to test a computer’s NIC forfunctionality?（）A、ping netB、ping ipconfigC、ping localhostD、ping microsoft.com
A technician notices a machine’s performance has degraded. The machine has constant errorswhen trying to read data from the drive. Which of the following should be used to repair the disk errors?（）A、DEFRAGB、MSCONFIGC、EDITD、CHKDSK
When testing a CAT5 cable, the technician notices that pin A is open. However, the cable stillworks fine. Which of the following describes how this is possible?（）A、The cable was tested for 100Base-TX.B、The cable is a 1000BaseT cable.C、The switch uses link aggregation,D、The switch was setup to use MDIX
A technician is setting up a new inkjet printer and notices that the images appear hazy. Which of the following should the technician perform FIRST to resolve the issue?（）A、Refill the cartridgesB、Replace the tonerC、Replace the network cableD、Calibrate the inkjet printer
A technician is dispatched to a malware infected system. Upon arrival, the technician notices themalware’s pop-up on the screen. Which of the following boot methods would the technician utilize?（）A、Reboot in Safe ModeB、Reboot in Recovery ConsoleC、Reboot in Last Known Good ConfigurationD、Reboot in System Debug Mode
The technician notices that one of the wires in a CAT5 cable is cut in half. Which of the followingconnectivity issues did the technician discover?（）A、Open pairsB、AttenuationC、CrosstalkD、Interference
A technician notices that when trying to ping a workstation by network name the workstation does not reply back over the network. The workstation is part of the domain and is able to get to the Internet. Which of the following is the cause of the problem？（）A、Faulty cable on the workstationB、Wrong host name on the workstationC、Wrong WINS on the workstationD、Incorrect IP address assigned to the workstation
A technician is servicing a customer’s color laser printer and notices excess toner in the printer.Which of the following tools would BEST assist the technician in removing the excess toner?（）A、Damp towelB、Compressed airC、Alcohol wipeD、Computer vacuum
A technician has a laptop that is running slow and notices the fan is on high. Which of the following should the technician try FIRST?（）A、Clean the heatsink assembly of debris.B、Turn the fan off when the AC adapter is attached.C、Turn the fan to low in the BIOS.D、Replace the processor and fan.
A technician is replacing a processor in a workstation. After installation, the workstation starts up and immediately shuts down; the technician tries to start the workstation several more times and gets the same result. Which of the following is the cause of this issue?（）A、The workstation is not plugged in.B、The thermal paste was not applied.C、The memory was not installed properly.D、The L2 cache was not cleared.
单选题Which of the following ping commands would a technician use to ping continuously?（）APING -lBPING -RCPING -tDPING -a
单选题A technician is replacing a processor in a workstation. After installation, the workstation starts up and immediately shuts down; the technician tries to start the workstation several more times and gets the same result. Which of the following is the cause of this issue?（）AThe workstation is not plugged in.BThe thermal paste was not applied.CThe memory was not installed properly.DThe L2 cache was not cleared.
单选题A user is present when a technician is troubleshooting their workstation. They insist on showing the technician, step by step, what occurred. How should the technician deal with this situation? （）AAllow the user to demonstrate expertise.BDo not argue; empathize with the user, and offer to help.CAsk the user to watch as the technician diagnoses and corrects the problem.DDocument each of the steps to replicate at a later time.
单选题When testing a CAT5 cable, the technician notices that pin A is open. However, the cable stillworks fine. Which of the following describes how this is possible?（）AThe cable was tested for 100Base-TX.BThe cable is a 1000BaseT cable.CThe switch uses link aggregation,DThe switch was setup to use MDIX
单选题While troubleshooting a network connectivity problem, a technician observes steady link lights on both the workstation NIC and the switch port to which the workstation is connected. However, when the ping command is issued from the workstation, the output message "Request timed out." is displayed. At which layer of the OSI model does the problem most likely exist?（）Athe session layerBthe protocol layerCthe data link layerDthe access layerEthe network layerFthe application layer
单选题A Windows user is trying to get to a shared folder on a server but is receiving an error message that multiple connections to the same resource are not allowed. Which of the following tools can the technician use from the user’s workstation to get the user reconnected as quickly as possible？（）Anbtstat with the/reload parameterBnbtstat with the/resolved parameterCnet use with the/delete parameterDnet use with the/persistent parameter
单选题A network technician wants to use a packet analyzer to troubleshoot a reported problem with a user's workstation with IP address 192.168.1.45. To identify the workstation's packets the technician wants to use the workstation's MAC address. Which of the following protocols would provide the needed information?（）ADHCPBARPCDNSDPING