单选题The Testking router is running both RIP and IGRP, and the same route is learned by this router from both of these methods. However, when you issue the command"show ip route" you see only the IGRP route, and not the RIP route. Why is this?（）AIGRP has a faster update timer.BIGRP has a lower administrative distance.CRIP has a higher metric value for that route.DThe IGRP route has fewer hops.EThe RIP path has a routing loop.
单选题
The Testking router is running both RIP and IGRP, and the same route is learned by this router from both of these methods. However, when you issue the command"show ip route" you see only the IGRP route, and not the RIP route. Why is this?（）
A
IGRP has a faster update timer.
B
IGRP has a lower administrative distance.
C
RIP has a higher metric value for that route.
D
The IGRP route has fewer hops.
E
The RIP path has a routing loop.
参考解析
解析：
暂无解析
相关考题：
下列对RIP的配置中，合法的命令是（）A.router rip 100 network 10.12.0.0B.router rip 100 network 10.0.0.0C.router rip network 10.12.0.0D.router rip 100 network 10.0.0.0
According to the following output, can you tell me which command can redistribute IGRP into EIGRP?() A. Under t he router eigrp mode add redistribute igrp 123 subnetsB. Under the router igrp mode add redistribute eigrp 123C. None, EIGRP and IGRP are automatically redistributed in this instance.D. Under the router eigrp mode add redistribute igrp 123
By default, how often does a router running IGRP send its complete routing table to its neighbors?() A. Every 5 minutesB. Every 90 secondsC. Every 60 secondsD. Every 30 seconds
Which IOS commands can a network technician use to verify all RIP, IGRP,EIGRP, and OSPF routing protocol configurations?() A. debug ip routingB. show running-configC. show ip route protocolsD. show ip protocolsE. show protocols al
You need to choose a routing protocol for a new Testking network. This network will be running IP, IPX, and Appletalk, and you wish to utilize only one routing protocol. Which one would be the best choice?（）A. OSPFB. EIGRPC. RIP v2D. IGRPE. RIP v1
Refer to the exhibit. When running OSPF, What would cause router A not to form an adjacency with router B?() A.The loopback addresses are on different subnetsB.The value of the dead timers on the router are differentC.Route summarization is enabled on both routersD.The process indentifier on router A is different than the process identifier on router B
One of the most widely used routing protocols in IP networks is the Routing Information Protocol（RIP）。RIP is the canonical example of a routing protocol built on the（ ）algorithm.Routing protocols in internetworks differ slightly from the idealized graph model.In an internetwork,the goal of the routers to forward packets to various（请作答此空）.Routers running RIP send their advertisement about cost every（ ）seconds.A router also sends an update message whenever an update from another router causes it to change its routing table.It is possible to use a range of different metrics or costs for the links in a routing protocol.RIP takes the simplest approach,with all link costs being equal（ ）。Thus it always tries to find the minimum hop route.Valid distances are 1 through（ ）。This also limits RIP to running on fairly small networks.A.computersB.routersC.switchesD.networks
Quidway路由器的路由协议的优先级别由高到低的排列顺序为（）。A、OSPF、STATIC、IGRP、RIPB、STATIC、RIP、OSPF、IGRPC、RIP、STATIC、OSPF、IGRPD、STATIC、OSPF、RIP、IGRP
A routing table contains static, RIP, and IGRP routes destined to the same network with each route set to its default administrative distance. Which route will be the preferred route?（）A、The RIP routeB、The static routeC、The IGRP routeD、All three will load balance.
The Testking router is running both RIP and IGRP, and the same route is learned by this router from both of these methods. However, when you issue the command"show ip route" you see only the IGRP route, and not the RIP route. Why is this?（）A、IGRP has a faster update timer.B、IGRP has a lower administrative distance.C、RIP has a higher metric value for that route.D、The IGRP route has fewer hops.E、The RIP path has a routing loop.
In which of the following scenarios would the "show cdp neighbors detail"command be an appropriate troubleshooting tool?（）A、Two switches are connected via a trunk. Both switches have been assigned an IP address, subnet mask, and default gateway. A ping is successful between the two switches. However, VLAN information is not passed from one switch to the other switch.B、A router and a switch have been assigned an IP address, a subnet mask, and a default gateway. They are directly connected, but a ping between the two devices fails.C、A router connects to another router through a serial interface. Both routers have been assigned an IP address, subnet mask, and default gateway. The routers are running RIP and the networks directly connected to the first router do not pass to the second router. However, a ping from one router to the serial interface of the directly connected neighboring router is successful.D、A router connects to another router via a switch. Both routers and the switch have been assigned an IP address, subnet mask, and default gateway. Neither the routers nor the switch are able to ping one of the hosts that is directly to the switch.
You need to choose a routing protocol for a new Testking network. This network will be running IP, IPX, and Appletalk, and you wish to utilize only one routing protocol. Which one would be the best choice?（）A、OSPFB、EIGRPC、RIP v2D、IGRPE、RIP v1
MSR路由器上配置RIP协议手工路由聚合的命令是（）。A、[Router]rip summar-address 10.1.0.022B、[Router-rip-1]rip summar-address 10.1.0.0C、[Router-rip-1]rip summar-address 10.1.0.022D、[Router-Serial1/0]rip summar-address 10.1.0.0 22
By default, how often does a router running IGRP send its complete routing table to its neighbors?（）A、Every 5 minutesB、Every 90 secondsC、Every 60 secondsD、Every 30 seconds
Which IOS commands can a network technician use to verify all RIP, IGRP,EIGRP, and OSPF routing protocol configurations?（）A、debug ip routingB、show running-configC、show ip route protocolsD、show ip protocolsE、show protocols al
多选题Which IOS commands can a network technician use to verify all RIP, IGRP,EIGRP, and OSPF routing protocol configurations?（）Adebug ip routingBshow running-configCshow ip route protocolsDshow ip protocolsEshow protocols al
以下路由协议中，属于IGP 的是以下哪项？ (1.0分) [单选.] A. OSPF.EGP.RIP B. IS-IS.RIP-2.EIGRP.OSPF C. BGP.IGRP.RIP D. PPP.RIP.OSPF.IGRP