多选题What can be determined from the line of show ip route output shown in the exhibit?（）AThe next routing update can be expected in 35 seconds.BThe IP address 10.10.10.6 is configured on S0/1.CThe IP address 10.10.10.8 is configured on S0/1.DThis route is using the default administrative distance.EThe 10.10.10.8 network is two hops away from this router.
多选题
What can be determined from the line of show ip route output shown in the exhibit?（）
A
The next routing update can be expected in 35 seconds.
B
The IP address 10.10.10.6 is configured on S0/1.
C
The IP address 10.10.10.8 is configured on S0/1.
D
This route is using the default administrative distance.
E
The 10.10.10.8 network is two hops away from this router.
参考解析
解析：
暂无解析
相关考题：
An administrator issues the show ip interface s0/0 command and the output displays that interface Serial0/0 is up, line protocol is up.What does "line protocol is up" specifically indicate about the interface?A．The cable is attached properly.B．CDP has discovered the connected device.C．Keepalives are being received on the interface.D．A carrier detect signal has been received from the connected device.E．IP is correctly configured on the interface.
Which line from the output of the show ip interface command indicates that there is a Layer 1 problem?A．Serial0/1 is up, line protocol is downB．Serial0/1 is down, line protocol is downC．Serial0/1 is up, line protocol is upD．Serial0/1 is administratively down, line protocol is downE．None of the above
The fol lowing line of output was extracted from the output of the show ip bgp command on Router R1. Which of the following can be determined from this output?（）Network Next Hop Metric LocPrf Weight Path* 130.1.1.0/28 1.1.1.1 0 1 2 3 4 iA. The route is learne d from an eBGP peerB. The route has no more than three ASNs in the AS_PatHC. The route is the best route for this prefixD. None of these facts can be positively determined by this output
Which of the following can either directly or indirec tly identify all the interfaces for which both 1) OSPF has been enabled and 2) OSPF is not passive?() A. show ip ospf databaseB. show ip ospf interface briefC. show ip protocolsD. show ip route ospfE. show ip ospf neighbors
A network design shows that R1 has four different possible paths from itself to the Data Center subnets.Which one of the following commands is most likely to show you all the possible next - hop IP addresses for these four possible routes?（）A. show ip eigrp topologyB. show ip eigrp topology all - linksC. show ip route eigrpD. show ip route eigrp all - linksE. show ip eigrp topology all - learned
Which BGP command provides the router ID, local preference, next hop, and BGP path in its output?() A. show ip route bgpB. show ip bgpC. show ip bgp neighborsD. show ip bgp summary
Above is the output from show ip bgp neighbors command. What is line 21 stating about the BGP connection?() A. the number of consecutive TCP connections to the specified remote neig hborB. the number of total TCP connections that the router hasC. the number of times the router has established a TCP connectionD. the number of neighbors that the router has
Which IOS commands can a network technician use to verify all RIP, IGRP,EIGRP, and OSPF routing protocol configurations?() A. debug ip routingB. show running-configC. show ip route protocolsD. show ip protocolsE. show protocols al
Refer to the output. What IOS command produces this output?() A. show i p ospfB. show ip ospf interfaceC. show ipv6 ospf interfaceD. show ipv6 ospf
What command visualizes the general NetFlow data on the command line?() A.show ip flow exportB.show ip flow top-talkersC.show ip cache flowD.show mls samplingE.show mls netflow ip
Users on the 172.17.22.0 network cannot reach the server located on the 172.31.5.0 network.The network administrator connected to console port,issued the show ip route command,and was able to ping the server.Based on the output of the show ip route command topology shown in the graphic,what is the cause of the failure?（）A.IP routing is not enabledB.A static route is configured incorrectlyC.The network has not fully convergedD.The FastEthernet interface on Coffee is disabledE.The routing table on Coffee has not updatedF.The neighbor relationship table is not correctly updated
Refer to the exhibit. What can be determined about the router from the console output?() A.No configuration file was found in NVRAM.B.No configuration file was found in flash.C.No configuration file was found in the PCMCIA card.D.Configuration file is normal and will load in 15 seconds.
What can be determined from the line of show ip route output shown in the exhibit?（）A、The next routing update can be expected in 35 seconds.B、The IP address 10.10.10.6 is configured on S0/1.C、The IP address 10.10.10.8 is configured on S0/1.D、This route is using the default administrative distance.E、The 10.10.10.8 network is two hops away from this router.
Which BGP command provides the router ID, local preference, next hop, and BGP path in its output?（）A、show ip route bgpB、show ip bgpC、show ip bgp neighborsD、show ip bgp summary
Which of the following commands can be used to gather information about the AS-PATH of a BGProute？ （Choose all that apply.）（）A、show ip bgp neighborsB、debug ip bgp updatesC、show ip route bgpD、show ip bgpE、show ip bgp summaryF、sh ip bgp database
What command visualizes the general NetFlow data on the command line?（）A、show ip flow exportB、show ip flow top-talkersC、show ip cache flowD、show mls samplingE、show mls netflow ip
Which of the following commands will enable you to see the contents of the IP routing table andsend the output to a TFTP server at the same time？（）A、show ip route ∣ to tftp：//192.168.1.1/route.txtB、show ip route ∣ tee tftp：//192.168.1.1/route.txtC、show ip route ∣ include tftp：//192.168.1.1/route.txtD、show ip route ft include tJtp：//19Z168.1.1/route.txtE、show ip route ∣ redirect tftp：//192.168.1.1/route.txt
What are two Cisco IOS commands that can be used to view neighbor adjacencies?（）A、show ip ospf interfacesB、show ip ospf protocolsC、show ip ospf neighborsD、show ip ospf database
Which IOS commands can a network technician use to verify all RIP, IGRP,EIGRP, and OSPF routing protocol configurations?（）A、debug ip routingB、show running-configC、show ip route protocolsD、show ip protocolsE、show protocols al
Which line from the output of the show ip interface command indicates a layer 1 problem?（）A、Serial0/1 is up, line protocol is downB、Serial0/1 is down, line protocol is downC、Serial0/1 is up, line protocol is upD、Serial0/1 is administratively down, line protocol is down
The following line of output was gathered on Enterprise Router Ent1 using the command show ip route. Which of the following answers is most likely to be true, based on thi s output？（） B 128.107.0.0 [20/10] via 11.11.11.11, 00:02:18A、This router has set the Weight of this route to 10.B、This router's BGP table lists this route as an iBGP route.C、This router's MED has been set to 10.D、This router's BGP table lists an AS_Path length of 10 for this route.
A network design shows that R1 has four different possible paths from itself to the Data Center subnets. Which one of the following commands is most likely to show you all the possible next - hop IP addresses for these four possible routes?（）A、show ip eigrp topologyB、show ip eigrp topology all - linksC、show ip route eigrpD、show ip route eigrp all - linksE、show ip eigrp topology all - learned
Which of the following can either directly or indirec tly identify all the interfaces for which both 1) OSPF has been enabled and 2) OSPF is not passive?（）A、show ip ospf databaseB、show ip ospf interface briefC、show ip protocolsD、show ip route ospfE、show ip ospf neighbors
Which command will display only direct routes?（）A、show routeB、show route inet 0 directC、show ip route directD、show ip route protocol direct
单选题The following line of output was gathered on Enterprise Router Ent1 using the command show ip route. Which of the following answers is most likely to be true, based on thi s output？（） B 128.107.0.0 [20/10] via 11.11.11.11, 00:02:18AThis router has set the Weight of this route to 10.BThis router's BGP table lists this route as an iBGP route.CThis router's MED has been set to 10.DThis router's BGP table lists an AS_Path length of 10 for this route.
单选题The fol lowing line of output was extracted from the output of the show ip bgp command on Router R1. Which of the following can be determined from this output?（） Network Next Hop Metric LocPrf Weight Path * 130.1.1.0/28 1.1.1.1 0 1 2 3 4 iAThe route is learne d from an eBGP peerBThe route has no more than three ASNs in the AS_PatHCThe route is the best route for this prefixDNone of these facts can be positively determined by this output
多选题The following output on Router R1 lists details of a BGP route for 190.1.0.0/16. Which of the following is true based on this output?（） R1# show ip bgp 19 0.1.0.0/16 BGP routing table entry for 190.1.0.0/16, version 121 Paths: (1 available, best #1, table Default - IP - Routing - Table) Advertised to update - groups: 1 1 2 3 4 1.1.1.1 from 2.2.2.2 (3.3.3.3) Origin IGP, metric 0, localpref 100, valid, internal, bestAR1 has a neighbor 1.1.1.1 command configured.BR1 has a neighbor 2.2.2.2 command configured.CThe show ip bgp command lists a line for 190.1.0.0/16 with both an and an i on the left.DR1 is in ASN 1.