单选题While running 'lsvg -l rootvg', an administrator notices that the quantity of LPs and PPs are different. What is the likely cause?（）AThe LPs represent a section of logical storage that can be mapped to multiple PPs.BThe PPs represent the mapping to the physical disk. There will always be either equal or fewer PPs than LPs.CThe LPs represent a section of logical storage that is mapped to a PP that spans over multiple physical disks.DThe LP represents a section of logical storage. This is mirrored on the filesystem level which creates a greater number of PPs.
单选题
While running 'lsvg -l rootvg', an administrator notices that the quantity of LPs and PPs are different. What is the likely cause?（）
A
The LPs represent a section of logical storage that can be mapped to multiple PPs.
B
The PPs represent the mapping to the physical disk. There will always be either equal or fewer PPs than LPs.
C
The LPs represent a section of logical storage that is mapped to a PP that spans over multiple physical disks.
D
The LP represents a section of logical storage. This is mirrored on the filesystem level which creates a greater number of PPs.
参考解析
解析：
暂无解析
相关考题：
After mirroring rootvg, a system administrator wants to validate that the system will boot correctly.Which of the following tasks must be performed before changing the boot order?() A.Run a bosboot -a commandB.Mirror the hd5 on the two disksC.Set up another service mode bootlistD.Check the disks using a lsvg -p rootvg command
Thedataondatavgisinaccessible.Using"df"theuserdiscoversthatnoneofthedatavgfilesystemsaremounted.Running"lsvg"showsonlyrootvg.Running"importvg-y"givesthefollowingerror:"056-056volumecannotbevariedonbecausepvismarkedmissing".Whichofthefollowingstepsshouldbeperformed?（）A.Runcfgmgr.B.Runsynclvodm.C.Lookinerrorlogforhardwareproblems.D.Bootintoservicemodeandrunfsckonfilesystems.
Which of the following is the correct command to list the filesystems in datavg?() A. lsvg -p datavgB. lsvg -l datavgC. lsvg -L datavgD. lsvg -o datavg
While troubleshooting a connectivity problem, a network administrator notices that a port status LED on a Cisco Catalyst series switch is alternating green and amber. Which condition could this indicate（）。A、The port is experiencing errorsB、The port is administratively disabledC、The port is blocked by spanning treeD、The port has an active link with normal traffic activity
In order to eliminate single points of failure before installing HACMP， the rootvg should be mirrored. What command needs to be performed in order to verify the rootvg is mirrored and syncd？（） A、 lslv -M hd5B、 lspv rootvgC、 lsvg -I rootvgD、 bootlist -m normal hdisk#
The system administrator has been getting complaints about slow performance from the server. After running vmstat the administrator notices average readings that show the free list （fre） approaching zero， as well as page-in （pi） and page-out （po） values to be high. Furthermore， the applications running are essential to daily business operations. Which of the following recommendations would provide the best overall improvement？（）A、 Increase physical diskB、 Increase number of CPU’sC、 Increase physical memoryD、 Increase number of servers
An administrator wants to create a new 100 GB virtual media repository in the rootvg storage pool on the Virtual IO server. Which command will accomplish this？（）A、 mklv -sp rootvg ize 100gbB、 crrep p rootvg ize 100gbC、 mkrep p rootvg ize 100gbD、 crfs jfs2 rootvg size=100gb
While reviewing the backup logs a server administrator notices that a backup job for an application server on the same subnet has failed. Which of the following is MOST likely the problem？（）A、The remote agent was not running.B、The management card has failed.C、The proxy server was blocking access.D、The hardware firewall was blocking access.
An administrator logs into a server and notices slow performance.While troubleshooting the problem the administrator notices that an unfamiliar process in the Task Manager is running at 100% CPU usage.The administrator tries to end the task and receives ‘Access is denied’. Which of the following steps would allow the administrator to terminate that process？（）A、Adding the ‘Run as a service’ permission to their account.B、Running the kill utility.C、Adding their account to the remote users group.D、Ending the services.exe process then ending the runaway process.
After mirroring rootvg, a system administrator wants to validate that the system will boot correctly. Which of the following tasks must be performed before changing the boot order?（）A、Run a bosboot -a commandB、Mirror the hd5 on the two disksC、Set up another service mode bootlistD、Check the disks using a lsvg -p rootvg command
After a system has rebooted from a system crash, which of the following commands should be run to find the location of the dump?（）A、 lsvg -l rootvg B、 sysdumpdev -e C、 sysdumpdev -L D、 cd /var/adm/ras
How can an administrator determine how many physical copies there are of a mirrored logical volume in rootvg（）A、lslv rootvgB、lsvgs rootvgC、lsvg rootvgD、lspv hdisk0
While running 'lsvg -l rootvg', an administrator notices that the quantity of LPs and PPs are different. What is the likely cause?（）A、The LPs represent a section of logical storage that can be mapped to multiple PPs.B、The PPs represent the mapping to the physical disk. There will always be either equal or fewer PPs than LPs.C、The LPs represent a section of logical storage that is mapped to a PP that spans over multiple physical disks.D、The LP represents a section of logical storage. This is mirrored on the filesystem level which creates a greater number of PPs.
Using splitvg to create a snapshot volume group of rootvg results in an error. What is the most likely cause of the error（）A、There is not an available disk to allocate to the snapshot volume groupB、One of the physical volumes associated with rootvg has a status of "missing"C、Rootvg is running in enhanced concurrent modeD、A snapshot volume group cannot be created for the rootvg
The data on datavg is inaccessible. Using "df" the user discovers that none of the datavg filesystems are mounted. Running "lsvg" shows only rootvg. Running "importvg -y" gives the following error: "056-056 volume cannot be varied on because pv is marked missing". Which of the following steps should be performed?（）A、Run cfgmgr. B、Run synclvodm. C、Look in errorlog for hardware problems. D、Boot into service mode and run fsck on filesystems.
Which of the following is the correct command to list the filesystems in datavg?（）A、lsvg -p datavgB、lsvg -l datavgC、lsvg -L datavgD、lsvg -o datavg
Which command would an administrator use to list which filesystems are in volume group datavg？（）A、lspv datavgB、lslv -a datavgC、lsfs -v datavgD、lsvg -l datavg
The ‘lsvg -o’ command is run with an output of only rootvg， but the server has another volume group named datavg， which is not displayed. What is the likely cause？（）A、datavg is in an offline state.B、‘lsvg -o’ only displays the root volume group.C、‘lsvg -o’ only displays the fist volume group.D、datavg has no filesystems and therefore， is inactive.
单选题In order to eliminate single points of failure before installing HACMP， the rootvg should be mirrored. What command needs to be performed in order to verify the rootvg is mirrored and syncd？（）A lslv -M hd5B lspv rootvgC lsvg -I rootvgD bootlist -m normal hdisk#
单选题While reviewing the backup logs a server administrator notices that a backup job for an application server on the same subnet has failed. Which of the following is MOST likely the problem？（）AThe remote agent was not running.BThe management card has failed.CThe proxy server was blocking access.DThe hardware firewall was blocking access.
单选题The system administrator has been getting complaints about slow performance from the server. After running vmstat the administrator notices average readings that show the free list （fre） approaching zero， as well as page-in （pi） and page-out （po） values to be high. Furthermore， the applications running are essential to daily business operations. Which of the following recommendations would provide the best overall improvement？（）A Increase physical diskB Increase number of CPU’sC Increase physical memoryD Increase number of servers
单选题An administrator needs to replace a failed internal disk in a mirrored rootvg. Which of the following is one of the steps that must be followed（）ADeallocate rootvg mirrorBUse hot replace managerCBreak rootvg mirrorDDeallocate LPs from failed disk
单选题An administrator wants to create a new 100 GB virtual media repository in the rootvg storage pool on the Virtual IO server. Which command will accomplish this？（）A mklv -sp rootvg ize 100gbB crrep p rootvg ize 100gbC mkrep p rootvg ize 100gbD crfs jfs2 rootvg size=100gb
单选题After a system has rebooted from a system crash, which of the following commands should be run to find the location of the dump?（）A lsvg -l rootvg B sysdumpdev -e C sysdumpdev -L D cd /var/adm/ras
单选题While troubleshooting a connectivity problem, a network administrator notices that a port status LED on a Cisco Catalyst series switch is alternating green and amber. Which condition could this indicate（）。AThe port is experiencing errorsBThe port is administratively disabledCThe port is blocked by spanning treeDThe port has an active link with normal traffic activity
单选题An administrator logs into a server and notices slow performance.While troubleshooting the problem the administrator notices that an unfamiliar process in the Task Manager is running at 100% CPU usage.The administrator tries to end the task and receives ‘Access is denied’. Which of the following steps would allow the administrator to terminate that process？（）AAdding the ‘Run as a service’ permission to their account.BRunning the kill utility.CAdding their account to the remote users group.DEnding the services.exe process then ending the runaway process.
单选题The 'lsvg -o' command is run with an output of only rootvg, but the server has another volume group named datavg, which is notdisplayed. What is the likely cause?（）Adatavg is in an offline state.B'lsvg -o' only displays the root volume group.C'lsvg -o' only displays the fist volume group.Ddatavg has no filesystems and therefore, is inactive.
单选题While running 'lsvg -l rootvg', an administrator notices that the quantity of LPs and PPs are different. What is the likely cause?（）AThe LPs represent a section of logical storage that can be mapped to multiple PPs.BThe PPs represent the mapping to the physical disk. There will always be either equal or fewer PPs than LPs.CThe LPs represent a section of logical storage that is mapped to a PP that spans over multiple physical disks.DThe LP represents a section of logical storage. This is mirrored on the filesystem level which creates a greater number of PPs.